If I remember correctly (not a sure thing these days) you need to check the "Productivity Macros" in the "Installation Options" box. This will should load:
mchevnt=E:\SM11-5\MILL\QUIKSTEP\MCHEV11.PCB options=E:\SM11-5\MILL\QUIKSTEP\QUIKSTP.PCB <john> Bob Looney wrote: > hmmm. I don't see it on a cd. Maybe it was on an old set of floppies from V8 > era?. I chucked my floppies so maybe somebody may have it. John G. at SDRC > will know about it, they are "SmartCAM productivity Macros". I can zip the > folder if you need it. > bob > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Jon Baker > Sent: Thursday, November 16, 2000 3:42 PM > To: 'Smartcam Users Group (E-mail)' > Subject: Re: [mfg-smartcam] Misc Stuff > > Hey cool, I'm gonna have to spend more time looking over that CD, and less > time chasing porn on the internet. > :o) > Thanks Bob > Jon > ----- Original Message ----- > From: "Bob Looney" <[EMAIL PROTECTED]> > To: "'Jon Baker'" <[EMAIL PROTECTED]>; " 'Smartcam Users Group (E-mail)'" > <[EMAIL PROTECTED]> > Sent: Thursday, November 16, 2000 3:05 PM > Subject: RE: [mfg-smartcam] Misc Stuff > > > it's a non standard mchev11.pcb file in my sm11\quickstep folder. I think > > the quickstep executable is on the cd somewhere. > > bob > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED]]On Behalf Of Jon Baker > > Sent: Thursday, November 16, 2000 2:39 PM > > To: Smartcam Users Group (E-mail) > > Subject: Re: [mfg-smartcam] Misc Stuff > > > > > > Where did you get that. I just checked under freeform, and there is no > > "Misc. Options" Anybody know where this came from and better yet, how I > can > > get it too? > > Jon > > > > ----- Original Message ----- > > From: "Mike Sharp" <[EMAIL PROTECTED]> > > To: "Smartcam Users Group (E-mail)" <[EMAIL PROTECTED]> > > Sent: Thursday, November 16, 2000 12:55 PM > > Subject: [mfg-smartcam] Misc Stuff > > > > > > > Hi everyone > > > > > > I am using PM11.5. Under Create, Machine Events, Misc Options There is a > > > panel with M00, M01, Block Delete and Message. How do I access this info > > in > > > my template file? > > > > > > Thanks > > > Mike > > > ====================================================================== > > > To find out more about this mailing list including how to unsubscribe, > > > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > > > ====================================================================== > > > > > > > > > > ====================================================================== > > To find out more about this mailing list including how to unsubscribe, > > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
