Colin-
I think this is what you are after:
===============================
Topic: Can't Create/ Geometry/ Line with Step using keyboard input in the dialog box
SDRC/CAMAX
TECHNICAL SUPPORT GROUP
Technote
170
Date:
12/17/97
Author:
JM
Product
Production Turning
Advanced Turning
Version
v11.0
Problem:
When inserting with a turning tool, cannot input start and end coordinates in the
Create/ Geometry/ Line
dialog box using the keyboard.
Solution:
This problem can be corrected by down loading the appropriate patch for your
application from
http://www.I-deas.com/nav/support-training/product-updates/patches/patches.html
====================================
Jason Otto
SDRC ASC - Minneapolis, MN USA
"Williams, Colin" wrote:
> I have another question.
>
> We just installed pturn v11.0 on another computer, I noticed when I fill in
> "z" & d" by itself it goes through all the fields and nothing shows up.
> However when I highlight "start point" & end point I get my geometry. I
> remember there was a tech note about this.
>
> Thank you
>
> Colin Williams
>
> WABTEC CORPORATION CONFIDENTIALITY NOTE
> The content contained in this e-mail transmission is legally privileged and
>confidential information intended only for the use of the individual or entity named
>herein. If the reader of this transmission is not the intended recipient, you are
>hereby notified that any dissemination, distribution, or copying of this transmission
>is strictly prohibited.
> ======================================================================
> To find out more about this mailing list including how to unsubscribe,
> send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> ======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
