Is anyone else getting double posts. Thought it was just at home, but happening at work also.
Mike ----- Original Message ----- From: Alfaro, Steve <[EMAIL PROTECTED]> To: Williams, Colin <[EMAIL PROTECTED]>; Smartcam Forum (E-mail) <[EMAIL PROTECTED]> Sent: Tuesday, November 27, 2001 2:09 PM Subject: RE: [mfg-smartcam] DNC Software > Colin, > > We use Spectrum DNC. The software is good, but most any DNC software will do > the trick. The reason we went with Spectrum was that they set up our > hardware connection so that our machinists only have to run a laser-pen > across a bar-code and the program is loaded into the control. Using the > barcode method helps us to keep track of what is loaded and when it is > loaded. So far it has worked pretty good. > > One caveat though: If you choose to go with Spectrum, make sure that they > finish ALL your machines at one time. Their service people are so busy in > the field that there tends to be a re-learning curve whenever they come back > to do more work. > > Hope that helps a bit, I know it took us over a year to decide on the right > way to tackle this issue. > > Regards, > Stephen Alfaro > > Manufacturing Engineering Group > Flowserve Corp - Engineered Pump Division > Los Angeles, California > > -----Original Message----- > From: Williams, Colin [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, November 27, 2001 9:26 AM > To: Smartcam Forum (E-mail) > Subject: [mfg-smartcam] DNC Software > > > Is there a DNC software that can allow you to send or receive programs from > your computer, instead of going out to the machines in the plant to do the > same. > > Thank you > > > Colin Williams > > > WABTEC CORPORATION CONFIDENTIALITY NOTE > The content contained in this e-mail transmission is legally privileged and > confidential information intended only for the use of the individual or > entity named herein. If the reader of this transmission is not the intended > recipient, you are hereby notified that any dissemination, distribution, or > copying of this transmission is strictly prohibited. > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
