I haven't been following this thread, but here's a COP reference. I did a COP on my 1.6, it ran the same and I lost tach function (I think my twitchy tach couldn't deal with it, but who knows.. the Link still had signal just not the gauge). I reverted back to stock coils.
....and I spent more than $70 to do it.
Wallyman
Rob Ebersol
<[email protected]>
Sent by: To
miatapower-boun...@miat Eric Schieb
apower.net <[email protected]>
cc
Miatapower Miata Power
05/04/2009 09:44 AM <[email protected]>
Subject
Re: MSD LS1/LS6 Coils?
I'm still not sure I'm sold on the value (as in return on $/time
spent) of a COP when MSD makes a high power wasted spark coil for
$70. I suppose the absence of leads. Then again I haven't seen before/
after comparisons of any alternatives at this point, and haven't seen
any evidence that I've got spark issues with the stock 1.6 coil/ign.
Then again, I'm not making much more than 300whp. For $70 though, it
might be worth it to check for a power gain and replace a twenty year
old coil. I'd probably be pleasantly surprised.
I've decided to stick with the LINK in the name of cheap. It works
and it is worth more to me than anybody who would buy it. I was
briefly considering the Adaptronic - which looks like a sensational
unit for $1k.
http://boundaryengineering.com/adaptronicecumiatana.php
On May 3, 2009, at 10:34 PM, Eric Schieb wrote:
> In my case, I did not connect the high tension leads together as in
> a typical double-ended, wasted-spark, OEM installation. All coils
> were run normally ("grounded to the block itself"). They were
> simply fired every engine revolution on each of the paired
> cylinders. This cut down on the number of outputs that were needed
> from the ECU.
>
> RE:>would you not be firing the coil far more often that if in the
> originally designed environment with a four cylinder and with
> wasted spark?
>
> Yes. (Assuming the coils came off of a fully synchronous
> application and were not fired multiple times per combustion event
> and . . .)
>
> RE:>Given the dwell is set to OE-
>
> If you can not control your dwell, choose your coils carefully.
>
> FWIW, I noticed a Motec ECU on Ebay is currently at $1000.
>
> I was typically running 1.5 to 2 ms of dwell with the LS2 truck coils.
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
<<inline: graycol.gif>>
<<inline: pic28747.gif>>
<<inline: ecblank.gif>>
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
