Now I'm all upgraded to 5.1.... I'm very happy with it all, other than a few
minor issues,
most notably:
I am still getting 300 kilobytes/second download speed with OpenBSD pppoe,
however when
I plug directly into a Mac and run pppoe on it, 3 megabytes/second.
What should I look at for tuning this to get 3MB/s through OpenBSD?
Connection: pppoe, over fibre, 30M downlink, 1M uplink
The OpenBSD gateway is using the kernel pppoe driver.
...
OpenBSD 5.1 (GENERIC) #160: Sun Feb 12 09:46:33 MST 2012
dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Geode(TM) Integrated Processor by National Semi ("CyrixInstead"
586-class) 301 MHz
cpu0: FPU,TSC,MSR,CX8,CMOV,MMX
real mem = 132182016 (126MB)
avail mem = 119992320 (114MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 07/18/01, BIOS32 rev. 0 @ 0xfae40, SMBIOS
rev. 2.2 @ 0xf0800 (42 entries)
bios0: vendor Award Software International, Inc. version "6.00 PG" date
07/18/2001
apm0 at bios0: Power Management spec V1.2
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xb2c8
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfdb70/80 (3 entries)
pcibios0: PCI Exclusive IRQs: 10 11 12
pcibios0: no compatible PCI ICU found: ICU vendor 0x1078 product 0x0100
pcibios0: Warning, unable to fix up PCI interrupt routing
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xc0000/0x8000
cpu0 at mainbus0: (uniprocessor)
cpu0: TSC disabled
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00
rl0 at pci0 dev 14 function 0 "Realtek 8139" rev 0x10: irq 12, address
00:90:0b:04:bb:f1
rlphy0 at rl0 phy 0: RTL internal PHY
rl1 at pci0 dev 15 function 0 "Realtek 8139" rev 0x10: irq 10, address
00:90:0b:04:bb:f2
rlphy1 at rl1 phy 0: RTL internal PHY
rl2 at pci0 dev 16 function 0 "Realtek 8139" rev 0x10: irq 11, address
00:90:0b:04:bb:f3
rlphy2 at rl2 phy 0: RTL internal PHY
