6.8 seems to work OK on the Arm64 Pine A64+ with 1GB RAM. Some observations:
OpenBSD sees 896MB of RAM and makes only 838MB available. When running Debian Linux on the exact same board the available RAM *after boot* is 994MB, a difference of more than 150MB. Perhaps this can be improved by tuning the DTB. A contrived test of network performance, using httpd(8) to serve a large file from an mfs ramdisk over plain http, yields about 175 mbit/s sustained transfer speed. I was not expecting to reach even 100 mbit/s so this was a positive surprise, even if it's nowhere near the full gigabit that other OSes can squeeze out of this board. ======== OpenBSD 6.8 (GENERIC.MP) #828: Sun Oct 4 20:35:47 MDT 2020 dera...@arm64.openbsd.org:/usr/src/sys/arch/arm64/compile/GENERIC.MP real mem = 940503040 (896MB) avail mem = 879267840 (838MB) random: good seed from bootblocks mainbus0 at root: Pine64+ psci0 at mainbus0: PSCI 1.1, SMCCC 1.2 cpu0 at mainbus0 mpidr 0: ARM Cortex-A53 r0p4 cpu0: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache cpu0: 512KB 64b/line 16-way L2 cache cpu1 at mainbus0 mpidr 1: ARM Cortex-A53 r0p4 cpu1: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache cpu1: 512KB 64b/line 16-way L2 cache cpu2 at mainbus0 mpidr 2: ARM Cortex-A53 r0p4 cpu2: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache cpu2: 512KB 64b/line 16-way L2 cache cpu3 at mainbus0 mpidr 3: ARM Cortex-A53 r0p4 cpu3: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache cpu3: 512KB 64b/line 16-way L2 cache efi0 at mainbus0: UEFI 2.8 efi0: Das U-Boot rev 0x20200700 apm0 at mainbus0 "display-engine" at mainbus0 not configured "osc24M_clk" at mainbus0 not configured "osc32k_clk" at mainbus0 not configured "internal-osc-clk" at mainbus0 not configured simpleaudio0 at mainbus0 "spdif-out" at mainbus0 not configured agtimer0 at mainbus0: tick rate 24000 KHz simplebus0 at mainbus0: "soc" sxisyscon0 at simplebus0 sxisid0 at simplebus0 sxiccmu0 at simplebus0 sxipio0 at simplebus0: 103 pins ampintc0 at simplebus0 nirq 224, ncpu 4 ipi: 0, 1: "interrupt-controller" sxirtc0 at simplebus0 sxiccmu1 at simplebus0 sxipio1 at simplebus0: 13 pins sxirsb0 at simplebus0 axppmic0 at sxirsb0 addr 0x3a3: AXP803 "de2" at simplebus0 not configured "dma-controller" at simplebus0 not configured "lcd-controller" at simplebus0 not configured "lcd-controller" at simplebus0 not configured sximmc0 at simplebus0 sdmmc0 at sximmc0: 4-bit, sd high-speed, mmc high-speed, dma "usb" at simplebus0 not configured "phy" at simplebus0 not configured ehci0 at simplebus0 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 configuration 1 interface 0 "Generic EHCI root hub" rev 2.00/1.00 addr 1 ohci0 at simplebus0: version 1.0 ehci1 at simplebus0 usb1 at ehci1: USB revision 2.0 uhub1 at usb1 configuration 1 interface 0 "Generic EHCI root hub" rev 2.00/1.00 addr 1 ohci1 at simplebus0: version 1.0 com0 at simplebus0sxiccmu_ccu_reset: 0x0000002e : ns16550, no working fifo com0: console sxitwi0 at simplebus0 iic0 at sxitwi0 dwxe0 at simplebus0: address 02:ba:06:9f:01:af rgephy0 at dwxe0 phy 1: RTL8169S/8110S/8211 PHY, rev. 5 "hdmi" at simplebus0 not configured "hdmi-phy" at simplebus0 not configured "interrupt-controller" at simplebus0 not configured sxidog0 at simplebus0 gpio0 at sxipio0: 32 pins gpio1 at sxipio0: 32 pins gpio2 at sxipio0: 32 pins gpio3 at sxipio0: 32 pins gpio4 at sxipio0: 32 pins gpio5 at sxipio0: 32 pins gpio6 at sxipio0: 32 pins gpio7 at sxipio0: 32 pins gpio8 at sxipio1: 32 pins usb2 at ohci0: USB revision 1.0 uhub2 at usb2 configuration 1 interface 0 "Generic OHCI root hub" rev 1.00/1.00 addr 1 usb3 at ohci1: USB revision 1.0 uhub3 at usb3 configuration 1 interface 0 "Generic OHCI root hub" rev 1.00/1.00 addr 1 "hdmi-connector" at mainbus0 not configured "binman" at mainbus0 not configured scsibus0 at sdmmc0: 2 targets, initiator 0 sd0 at scsibus0 targ 1 lun 0: <SD/MMC, 00000, 0000> removable sd0: 7620MB, 512 bytes/sector, 15605760 sectors vscsi0 at root scsibus1 at vscsi0: 256 targets softraid0 at root scsibus2 at softraid0: 256 targets bootfile: sd0a:/bsd boot device: sd0 root on sd0a (e07784d42ee158ca.a) swap on sd0b dump on sd0b ========