On Wed, 22 Sep 2021 17:27:30 +0100 "Patrick Harper" <paia...@fastmail.com> wrote:
> If the situation isn't going to change anytime soon then I have some > diffs for INSTALL.i386 and INSTALL.amd64. The latter has not specified > disk requirements, I guess since anyone who owns an amd64 system will > very likely be using a disk big enough for X, so I figured that the > same would apply to any user of an i386 system that meets the proposed > minimum RAM. These are based on the 2021-09-21 snapshot versions. > > --- INSTALL.i386.txt Wed Sep 22 16:52:38 2021 > +++ INSTALL.i386_new Wed Sep 22 16:51:17 2021 > @@ -201,10 +201,7 @@ OpenBSD/i386 7.0 supports most SMP (Symmetrical > MultiP > systems. To support SMP operation, a separate SMP kernel (bsd.mp) > is included with the installation file sets. > > -The minimal configuration to install the system is 32MB of RAM and > -at least 250MB of disk space to accommodate the `base' set. > -To install the entire system, at least 600MB of disk are required, > -and to run X or compile the system, more RAM is recommended. > +The minimal configuration to install the system is 512MB of RAM. > > Please refer to the website for a full list of supported hardware: > https://www.openbsd.org/i386.html Hello. I have Soekris net4801 gateway/firewall and it only has 128Mb of RAM. I usually upgrade to -current by putting the CF card into a different machine, since writing to CF card is slow on Soekris, but tonight I upgraded to -current using the box itself and timed how long it took to relink the kernel - 25 minutes. It has 256Mb of swap. Eh, 259.9M apparently. After-reboot relinking is currently disabled until I figure out what to put in the new bsd.re-config to change flags for wd to 0x0ff0 automatically, no luck yet. Soekris dmesg: OpenBSD 7.0 (GENERIC) #203: Wed Sep 22 19:24:38 MDT 2021 dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC real mem = 133709824 (127MB) avail mem = 114921472 (109MB) random: good seed from bootblocks mpath0 at root scsibus0 at mpath0: 256 targets mainbus0 at root bios0 at mainbus0: date 20/80/03, BIOS32 rev. 0 @ 0xf7840 pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000 pcibios0: pcibios_get_intr_routing - function not supported pcibios0: PCI IRQ Routing information unavailable. pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xc8000/0x9000 cpu0 at mainbus0: (uniprocessor) cpu0: Geode(TM) Integrated Processor by National Semi ("Geode by NSC" 586-class) 267 MHz, 05-04-00 cpu0: FPU,TSC,MSR,CX8,CMOV,MMX cpu0: TSC disabled pci0 at mainbus0 bus 0: configuration mode 1 (no bios) pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00 sis0 at pci0 dev 6 function 0 "NS DP83815" rev 0x00, DP83816A: irq 10, address 00:00:24:c3:54:68 nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1 sis1 at pci0 dev 7 function 0 "NS DP83815" rev 0x00, DP83816A: irq 10, address 00:00:24:c3:54:69 nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1 sis2 at pci0 dev 8 function 0 "NS DP83815" rev 0x00, DP83816A: irq 10, address 00:00:24:c3:54:6a nsphyter2 at sis2 phy 0: DP83815 10/100 PHY, rev. 1 ral0 at pci0 dev 10 function 0 "Ralink RT2860" rev 0x00: irq 11, address 00:1d:6a:0e:80:cd ral0: MAC/BBP RT2860 (rev 0x0101), RF RT2820 (MIMO 2T3R) ral1 at pci0 dev 14 function 0 "Ralink RT2560" rev 0x01: irq 5, address 00:13:d3:00:9f:7a ral1: MAC/BBP RT2560 (rev 0x04), RF RT2525 gscpcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00 gpio0 at gscpcib0: 64 pins "NS SC1100 SMI" rev 0x00 at pci0 dev 18 function 1 not configured pciide0 at pci0 dev 18 function 2 "NS SCx200 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 0: <CF Card> wd0: 1-sector PIO, LBA48, 3811MB, 7806960 sectors wd0(pciide0:0:0): using PIO mode 4 geodesc0 at pci0 dev 18 function 5 "NS SC1100 X-Bus" rev 0x00: iid 6 revision 3 wdstatus 0 ohci0 at pci0 dev 19 function 0 "Compaq USB OpenHost" rev 0x08: irq 9, version 1.0, legacy support isa0 at gscpcib0 isadma0 at isa0 com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo com0: console com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo pckbc0 at isa0 port 0x60/5 irq 1 irq 12 pckbd0 at pckbc0 (kbd slot) wskbd0 at pckbd0: console keyboard pcppi0 at isa0 port 0x61 spkr0 at pcppi0 nsclpcsio0 at isa0 port 0x2e/2: NSC PC87366 rev 9: GPIO VLM TMS gpio1 at nsclpcsio0: 29 pins gscsio0 at isa0 port 0x15c/2: SC1100 SIO rev 1: npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 usb0 at ohci0: USB revision 1.0 uhub0 at usb0 configuration 1 interface 0 "Compaq OHCI root hub" rev 1.00/1.00 addr 1 dt: 445 probes vscsi0 at root scsibus1 at vscsi0: 256 targets softraid0 at root scsibus2 at softraid0: 256 targets root on wd0a (1f081011692bae0c.a) swap on wd0b dump on wd0b