Hello, Hoping I can get help with an older Mac Powerbook G4 with a problem with X and the ATI driver. When exiting X the screen goes dark and the system looks like it's wedged. It's impossible to see what's going on. If I started with startx from the console, I can sometimes shut it down by blind typing the sudo shutdown command.
Tried 8 or 24 bit depth, full resolution or reduced to 1024x768. No different using startx or xdm (both hang). The wsfb driver works fine. It's very frustrating because I can't see what's going on. Where can I get more crash information? June 15 snapshot dmesg below. Thanks --Louis [ using 350956 bytes of bsd ELF symbol table ] console out [ATY,Xia_A]console in [keyboard] ADB found using parent ATY,XiaParent:: memaddr b8000000 size 8000000, : consaddr bc008000, : ioaddr b0020000, size 20000: memtag 8000, iotag 8000: width 1280 linebytes 1280 height 854 depth 8 Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2006 OpenBSD. All rights reserved. http://www.OpenBSD.org OpenBSD 3.9-current (GENERIC) #957: Thu Jun 15 14:42:19 MDT 2006 [EMAIL PROTECTED]:/usr/src/sys/arch/macppc/compile/GENERIC real mem = 536870912 (524288K) avail mem = 481984512 (470688K) using 1254 buffers containing 26841088 bytes (26212K) of memory mainbus0 (root): model PowerBook3,5 cpu0 at mainbus0: 7455 (Revision 0x302): 667 MHz: 256KB L2 cache, 1MB L3 cache memc0 at mainbus0: uni-n ki2c0 at memc0 offset 0xf8001000 iic0 at ki2c0 "Psoc" at iic0 addr 0xc4 not configured mpcpcibr0 at mainbus0 pci: uni-north, Revision 0xff pci0 at mpcpcibr0 bus 0 pchb0 at pci0 dev 11 function 0 "Apple Uni-N2 AGP" rev 0x00 vgafb0 at pci0 dev 16 function 0 "ATI Radeon Mobility M9 Lf" rev 0x01, mmio wsdisplay0 at vgafb0 mux 1: console (std, vt100 emulation) mpcpcibr1 at mainbus0 pci: uni-north, Revision 0x0 pci1 at mpcpcibr1 bus 0 pchb1 at pci1 dev 11 function 0 "Apple Uni-N2 Host" rev 0x00 macobio0 at pci1 dev 23 function 0 "Apple Keylargo" rev 0x03 openpic0 at macobio0 offset 0x40000: version 0x4614 macgpio0 at macobio0 offset 0x50 macgpio1 at macgpio0 offset 0x9 irq 47 "programmer-switch" at macgpio0 offset 0x11 not configured "firewire-linkon" at macgpio0 offset 0x5f not configured "gpio5" at macgpio0 offset 0x6f not configured "gpio6" at macgpio0 offset 0x70 not configured "extint-gpio4" at macgpio0 offset 0x5c not configured "gpio11" at macgpio0 offset 0x75 not configured "extint-gpio15" at macgpio0 offset 0x67 not configured "escc-legacy" at macobio0 offset 0x12000 not configured zsc0 at macobio0 offset 0x13000: irq 22,23 zstty0 at zsc0 channel 0 zstty1 at zsc0 channel 1 snapper0 at macobio0 offset 0x10000: irq 30,1,2 "timer" at macobio0 offset 0x15000 not configured adb0 at macobio0 offset 0x16000 irq 25: via-pmu, 3 targets akbd0 at adb0 addr 2: PowerBook G4 keyboard (Inverted T) wskbd0 at akbd0: console keyboard, using wsdisplay0 ams0 at adb0 addr 3: EMP trackpad <tpad> 2-button, 400 dpi wsmouse0 at ams0 mux 0 abtn0 at adb0 addr 7: brightness/volume/eject buttons apm0 at adb0: battery flags 0x4, 94% charged pi2c0 at adb0 iic1 at pi2c0 "battery" at macobio0 offset 0x0 not configured "backlight" at macobio0 offset 0xf300 not configured ki2c1 at macobio0 offset 0x18000 iic2 at ki2c1 wdc0 at macobio0 offset 0x1f000 irq 19: DMA wd0 at wdc0 channel 0 drive 0: <TOSHIBA MK4021GAS> wd0: 16-sector PIO, LBA, 38154MB, 78140160 sectors wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 wdc1 at macobio0 offset 0x20000 irq 20: DMA atapiscsi0 at wdc1 channel 0 drive 0 scsibus0 at atapiscsi0: 2 targets cd0 at scsibus0 targ 0 lun 0: <MATSHITA, CD-RW CW-8121A, BB21> SCSI0 5/cdrom removable cd0(wdc1:0:0): using BIOS timings, DMA mode 2 wi0 at macobio0 offset 0x30000 irq 57: wi0: Firmware 8.70 variant 1, address 00:30:65:0c:68:94 audio0 at snapper0 ohci0 at pci1 dev 24 function 0 "Apple USB" rev 0x00: irq 27, version 1.0 usb0 at ohci0: USB revision 1.0 uhub0 at usb0 uhub0: Apple OHCI root hub, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered ohci1 at pci1 dev 25 function 0 "Apple USB" rev 0x00: irq 28, version 1.0 usb1 at ohci1: USB revision 1.0 uhub1 at usb1 uhub1: Apple OHCI root hub, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered cbb0 at pci1 dev 26 function 0 "Texas Instruments PCI1410 CardBus" rev 0x02: irq 58 cardslot0 at cbb0 slot 0 flags 0 cardbus0 at cardslot0: bus 1 device 0 cacheline 0x8, lattimer 0x20 pcmcia0 at cardslot0 mpcpcibr2 at mainbus0 pci: uni-north, Revision 0x6 pci2 at mpcpcibr2 bus 0 pchb2 at pci2 dev 11 function 0 "Apple Uni-N2 Host" rev 0x00 "AT&T/Lucent FW322 1394" rev 0x00 at pci2 dev 14 function 0 not configured gem0 at pci2 dev 15 function 0 "Apple Uni-N GMAC" rev 0x01: irq 41, address 00:0a:95:91:e9:6c brgphy0 at gem0 phy 0: BCM5421 10/100/1000baseT PHY, rev. 1 uhidev0 at uhub1 port 1 configuration 1 interface 0 uhidev0: Logitech USB Receiver, rev 1.10/20.10, addr 2, iclass 3/1 ums0 at uhidev0: 16 buttons and Z dir. wsmouse1 at ums0 mux 0 bootpath: '/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]/bsd' boot device: wd0. root on wd0a rootdev=0x0 rrootdev=0xb00 rawdev=0xb02 WARNING: clock gained 4 days -- CHECK AND RESET THE DATE!