On Fri, 13 Oct 2006, Jeff Quast wrote: > Hi Stuart, SNIP > This machine looks really fun though! Thanks for the power stats, too! > > > obio0 at mainbus0 > > com0 at obio0 addr 0xfe800000 intr 28: ns16550a, 16 byte fifo > > com0: console > > I don't mind soldering -- but soldering what? Is this for com0? > > Thanks!!
embedded system h/w hacking, yippie. look for any pin headers, maybe 4 or 5 together. if there aren't any headers look for a 4 or 5 solder pads in roll. if you find either one of these then you need to first find which pin/pad is GND, then with this knowledge in hand you can start checking voltages on the other pins/pads. You may also find a dual roll of pins/pads of anywhere from 10 - 16 pins, most likely this is the JTAG port. WARNING, mucking about your h/w can 'cause premature failure. I've accidently shorted PWR to GND before, fortunately the DC power fuse failed. Unfortunately the fuse was a very SMALL fuse that was oh so fun to replace.