Hello,
I have 4.3 running flawlessly since almost three months on an old
machine used as firewall: now, in less than a week, it froze twice.
This time I managed to copy down what's on the screen.
uvm_fault (0xd3da32f0,0x79394000,0,1) -> e
fatal page fault (6) in supervisor mode
trap type 6 code 0 eip d0431978 cs 8 eflags 10293 cr2 79394336 cpl0
panic: trap type 6, code=0, pc=d0431978
Starting stack trace...
panic (d078aad0,0,d5239d00,0,d3c682b8) at panic+0x71
panic (d06d6307,6,0,d0431978,c044) at panic+0x71
trap() at trap+0x119
--- trap number 6 ---
ufs_gettadr (d5239d78,0,d5239dc0,d0372bd9,d078b3c0) at ufs_getaddr+0x230
VOP_GETADDR (d3d11b24,d5239db8,d3daf000,d3c62b8) at VOP_GETADDR+0x34
vn_stat (d3d11b24,d5239e98,d3c682b8,0,3c00055e) at vn_stat+0x24
sys_stat (d3c682b8,d5239668,d5239f58,0,36c) at sys_stat+0x70
syscall() at syscall+0x243
--- syscall (number 291) ---
0x25cc905:
End of stack trace
Syncing disks
(hope I wrote everything correctly).
The machine, once power-cycled, rebooted without a hitch, not even
complaining about disk corruption or anything.
Couldn't get to ddb, since I disabled it in sysctl.conf. Can't find
anything in the logs, nor any coredumps.
Here's the DMESG:
[EMAIL PROTECTED]:~ # dmesg
OpenBSD 4.3 (GENERIC) #698: Wed Mar 12 11:07:05 MDT 2008
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: AMD-K6(tm) 3D processor ("AuthenticAMD" 586-class) 551 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX
real mem = 133779456 (127MB)
avail mem = 121319424 (115MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 07/07/00, BIOS32 rev. 0 @ 0xf0570
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xc12
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf0b90/128 (6 entries)
pcibios0: PCI Interrupt Router at 000:01:0 ("SiS 85C503 System" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0x8000
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "SiS 530 PCI" rev 0x02
agp0 at pchb0: aperture at 0xe0000000, size 0x4000000
pciide0 at pci0 dev 0 function 1 "SiS 5513 EIDE" rev 0xd0: 530: DMA,
channel 0 configured to compatibility, channel 1 configured to compatibility
wd0 at pciide0 channel 0 drive 0: <SAMSUNG SV0842D>
wd0: 16-sector PIO, LBA, 8063MB, 16514064 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 4
atapiscsi0 at pciide0 channel 1 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <ASUS, CD-S400/A, 1.1C> SCSI0 5/cdrom
removable
cd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
pcib0 at pci0 dev 1 function 0 "SiS 85C503 System" rev 0xb3
"SiS 5595 System" rev 0x00 at pci0 dev 1 function 1 not configured
ppb0 at pci0 dev 2 function 0 "SiS 86C201 AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "SiS 530 VGA" rev 0xa2
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
eap0 at pci0 dev 6 function 0 "Ensoniq AudioPCI97" rev 0x06: irq 9
ac97: codec id 0x43525903 (Cirrus Logic CS4297 rev 3)
ac97: codec features headphone, 18 bit DAC, 18 bit ADC, No 3D Stereo
audio0 at eap0
midi0 at eap0: <AudioPCI MIDI UART>
rl0 at pci0 dev 10 function 0 "Realtek 8139" rev 0x10: irq 12, address
00:05:1c:0c:34:4f
rlphy0 at rl0 phy 0: RTL internal PHY
rl1 at pci0 dev 11 function 0 "Realtek 8139" rev 0x10: irq 10, address
00:a0:a2:00:39:a4
rlphy1 at rl1 phy 0: RTL internal PHY
rl2 at pci0 dev 12 function 0 "Realtek 8139" rev 0x10: irq 11, address
00:02:44:73:3f:08
rlphy2 at rl2 phy 0: RTL internal PHY
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi1 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
lm0 at isa0 port 0x290/8: LM78
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask e165 netmask fd65 ttymask fde7
mtrr: K6-family MTRR support (2 registers)
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
WARNING: / was not properly unmounted
I'm preparing a spare box so I can take this one offline and check
the disk, since I saw a message that pointed in that direction. Any
other suggestions are most welcome. Thanks in advance!
---Vic
