I didn't understand this part. "you want to send a BREAK over the serial line. from cu, you do this by typing ~# at the start of a line (i.e. press enter first). If you're connecting over SSH, you need to escape the first tilde since it's also used by SSH: ~~#"
I issue the "cu" command, it says Connected and after that I can't really type anything. I get no cursor after I see "Connected" Is that normal? Do I send BREAK only if I see POST messages from the Blade? Or should I go ahead and type "~#" even if I see no cursor. Also, this won't be over ssh. Please Clarify. Thanks a bunch On Mon, Oct 13, 2008 at 12:56 AM, Stuart Henderson <[EMAIL PROTECTED]> wrote: > On 2008-10-13, Vivek Ayer <[EMAIL PROTECTED]> wrote: >> does length affect the pinout? I mean I even tried just hooking up the >> null modem cable placing the two PC's backs to each other. It should >> work in that case, right? I'm not at the computer now, but I'll try >> the Ctrl+break. So the procedure would go: >> >> 1. hookup short null modem cable to each end ((only) one 9-pin female >> on P3 and one 25-pin male on Blade Serial Port A (not B or others?)), >> 2. the blade will be off, >> 3. then on the P3 issue the command as root: cu -l /dev/tty00 (assume >> this over cua00?) -s 9600, > > shouldn't make a difference here, but cua is intended for > connecting out. > >> 4. it should say connected on the P3, >> 5. then power on the Sun w/o keyboard and monitor, >> 6. wait for 30-60 seconds >> 7. should see POST messages in terminal >> 8. Hit Ctrl+Break? > > you want to send a BREAK over the serial line. from cu, you do > this by typing ~# at the start of a line (i.e. press enter first). > If you're connecting over SSH, you need to escape the first tilde > since it's also used by SSH: ~~# > >> 9. and I'm set with the OK> prompt? >> >> When exactly do I hit Ctrl+Break? Also, before I issue "cu", when I >> login to the P3 running OBSD, what do I set as the terminal type: >> VT100 or Sun? Correct my procedure if it's wrong. > > doesn't matter. > > if you don't see the startup messages, verify the cable really is > wired correctly, and/or plug in your rs232 tester (what do you mean > you don't have one ;-) and check the lines. > >>>> But the cable is short, so I got a regular extension cable to >>>> hook up to it. >>> >>> It might be advisable to get a longer null modem cable, as you know.. >>> the different between a null modem and strait through cable is the >>> pinout. > > there's no problem to plug a normal modem cable into a null modem > cable to make it longer..