Hi list, the most recent MIBs for OpenBSD is for 4.4 (OpenBSD 4.4: obsd-mibs44.tar), which can be downloaded from well-known
http://www.packetmischief.ca/openbsd/snmp/ However, I seem to have problems getting it running on a OpenBSD 4.6 based relayd setup (dmesg below). It builds okay from the ports, installs, but snmpwalk won't find the OIDs documented. Has anyone running SNMP MIBs from this source on a system OpenBSD 4.4+? Thanks & sorry for my bad english, Donald dmesg: OpenBSD 4.6 (GENERIC) #58: Thu Jul 9 21:24:42 MDT 2009 dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 499 MHz cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX real mem = 268009472 (255MB) avail mem = 250335232 (238MB) mainbus0 at root bios0 at mainbus0: AT/286+ BIOS, date 12/10/07, BIOS32 rev. 0 @ 0xfceb2 pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 pcibios0: pcibios_get_intr_routing - function not supported pcibios0: PCI IRQ Routing information unavailable. pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xe0000/0xa800 cpu0 at mainbus0: (uniprocessor) pci0 at mainbus0 bus 0: configuration mode 1 (bios) pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33 glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address 00:0d:b9:15:98:cc ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address 00:0d:b9:15:98:cd ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12, address 00:0d:b9:15:98:ce ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 0, 32-bit 3579545Hz timer, watchdog, gpio gpio0 at glxpcib0: 32 pins pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 0: <TRANSCEND> wd0: 1-sector PIO, LBA, 1911MB, 3915072 sectors wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 pciide0: channel 1 ignored (disabled) ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 15, version 1.0, legacy support ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 15 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1 isa0 at glxpcib0 isadma0 at isa0 com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo com0: console pcppi0 at isa0 port 0x61 midi0 at pcppi0: <PC speaker> spkr0 at pcppi0 npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 usb1 at ohci0: USB revision 1.0 uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1 biomask e3ef netmask ffef ttymask ffff mtrr: K6-family MTRR support (2 registers) nvram: invalid checksum softraid0 at root root on wd0a swap on wd0b dump on wd0b clock: unknown CMOS layout -- GRATIS f|r alle GMX-Mitglieder: Die maxdome Movie-FLAT! Jetzt freischalten unter http://portal.gmx.net/de/go/maxdome01