On Tue, Sep 1, 2015 at 2:12 PM, Highland, Glenn <glenn.highl...@digi.com> wrote: > I've performed the re-test you suggested below and attached the log showing > the results. > I did start MM in debug mode just so I could use it to enable the modem and > then I > ordered it to terminate gracefully, without having it connect to the cell > network. > > I then ran AT+CNMI? over ttyACM3 and got the same erroneous result and then > over ttyACM0 > which resulted in the good result, just as a check. > > As I understand it, the HE910-D is supposed to support command I/O over both > USB > endpoints - Telit issue?
Could you try with git master and not with 1.4.x? The #PORTCFG based dynamic port identification logic, which applies to the HE910, is only in git master. -- Aleksander https://aleksander.es _______________________________________________ ModemManager-devel mailing list ModemManager-devel@lists.freedesktop.org http://lists.freedesktop.org/mailman/listinfo/modemmanager-devel