Possible you need an AddModule mod_perl.c line in there somewhere... I'm
not such an experienced module-user with Apache for Win32...
Issac
PGP Key 0xE0FA561B - Fingerprint:
7E18 C018 D623 A57B 7F37 D902 8C84 7675 E0FA 561B
----- Original Message -----
From: "Brice D Ruth" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, September 07, 2001 00:00
Subject: Help w/ install [ActivePerl,W2K Server,Apache 1.3.20]
> I'm trying to simply get Apache/mod_perl working in W2K ... I've been
> trying to follow the steps outlined in messages I've found from
> searching through archives, but it seems I'm a bit stuck. My experience
> w/ Apache has always been in Linux or *BSD, so I'm somewhat lost when it
> comes to getting this going in W2k.
>
> I have Apache 1.3.20 installed - the httpd.conf is vanilla - I can
> access my server by going to http://localhost/ - so all is good there.
>
> I downloaded ActivePerl 629 (?) and it installed fine ... c:\perl\bin is
> in my path and seems to work fine. I ran PPM and had it install
> mod_perl from theoryx5.uwinnipeg.ca - everything seemed to run fine and
> in the end it asked me where to put mod_perl.so - the path I gave was
> c:/Program Files/Apache Group/Apache/modules - I later looked here and I
> could see mod_perl.
>
> I then added the following line to my httpd.conf:
>
> LoadModule perl_module modules/mod_perl.so
>
> and left everything else as it was. I now get the following when I try
> to start Apache:
>
> The Apache service is starting.
> Failed to start the Apache service.
> Note the errors or messages above, and press the <ESC> key to exit.
> (countdown)...
>
> I don't see any error messages that do me any good, config test returns
> Syntax OK and the error log shows nothing.
>
> What do I need to do?
>
> Any help would be greatly appreciated!
>
> Brice Ruth
>
