I'm curious to know, did your swing keel "bang" in the trunk at anchor or in stays
Not that I can remember.........The keel was raised or lowered into position using a "worm gear" which was operated by a crank on the aft end of the trunk. Since the weight of the keel was supported by the pivot pin, the worm gear would hold the keel in any position desired. It also kept the keel from swinging fore and aft when sailing in rough water. It was much easier to operate than the conventional winch and cable systems used on a lot of other boats..........and no fretting about the line slipping out of your hand and dropping the board. It helped fine tune the trim on the boat as well............ Lenny _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
