Hi Larry
We use lead on all our boats. Even in the centerboards.
Never have used steel in anything. Steel rusts and swells.
In fact all the Montgomery sailboats built after a certain date in 1987 are LEAD.
Have a good one Larry!
Bob (949) 489-8227
Hughston, Larry wrote:
Bob, I received a new centerboard from you and it is installed on my M-15.
Since I did not ask for a lead filled CB can I assume it has steel on the
inside? Are the lead filled CB's still the same total weight as the steel
filled ones?
Thanks Bob. ---Larry Hughston hull# 189.
-----Original Message-----
From: Bob [mailto:[EMAIL PROTECTED] Sent: Wednesday, December 22, 2004 10:07 AM
To: Norm Bundek; For and about Montgomery Sailboats
Subject: Re: M_Boats: Regarding the hole size in the center board
Norm
You could also tape the bottom of the hole, then fill the entire space with some mat fibers and epoxy to the top. After it cures, then re-drill the hole with a 3/8 drill bit.
In either case we do have lead filled centerboards available. These will never rust or crack.
Your close enough to come and get one.
Fair winds Bob (949) 489-8227
Norm Bundek wrote:
I did not change the opening to the hole. The cracks and voids were on the inside. I ended up using Bondo rather than 5 minute epoxy. I knew that I would have to file with a rasp to the correct internal size. Epoxy would have been like working in concrete.
Norm M15 #172 _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
