On Thu, Jan 14, 2010 at 12:17 AM, Cactus <rieman...@googlemail.com> wrote: > > > On Jan 14, 4:52 am, Case Vanhorsen <cas...@gmail.com> wrote: >> On Wed, Jan 13, 2010 at 11:43 AM, Bill Hart <goodwillh...@googlemail.com> >> wrote: >> > I believe I've managed to get a working release candidate (rc5) >> > together, and it is up on the website now for testing. >> >> > This version is actually a candidate for release, as it fixes all the >> > remaining tickets which needed to be fixed for the release. About the >> > only thing which needs to be done for a final release is change the >> > date of the actual release in the NEWS file and perhaps some other >> > minor bits of paperwork! >> >> > Thus, we can begin full testing both on linux and on Windows. I >> > believe the @MKDIR_P@ issue is also gone, so make install should also >> > work now. >> >> "make install" does work properly on a clean Linux build. That's fixed. >> >> When building on Windows 7 x64 using the SDK and the command line >> tools, "make check" fails. I see the following error in the output: >> >> Build started: Project: mpn.invert, Configuration: Release|x64 >> Compiling... >> t-invert.c >> c1 : fatal error C1083: Cannot open source file: >> '..\..\..\tests\mpn\t-invert.c': No such file or directory >> Build log was saved at >> "file://c:\src\mpir-1.3.0\build.vc9\mpir-tests\mpn.invert\x64\Release\BuildLog.htm" >> mpn.invert - 1 error(s), 0 warning(s) >> >> The file "t-invert-c" doesn't appear to be present in the rc5 tar file >> but it is present in the SVN trunk. >> >> I'll continue with the rest of my testing. > > Hi Case > > Have you looked at the memory allocation behavoiur since I switched on > alloca on Windows? I have lots of information in another thread. Summary: it's usually much better but in some situations, it still makes a lot of memory requests.
casevh > > Also have you been able to run your speed tests against the Windows > x64 versions of GMP and MPIR? > > Brian > > -- > You received this message because you are subscribed to the Google Groups > "mpir-devel" group. > To post to this group, send email to mpir-de...@googlegroups.com. > To unsubscribe from this group, send email to > mpir-devel+unsubscr...@googlegroups.com. > For more options, visit this group at > http://groups.google.com/group/mpir-devel?hl=en. > > > >
-- You received this message because you are subscribed to the Google Groups "mpir-devel" group. To post to this group, send email to mpir-de...@googlegroups.com. To unsubscribe from this group, send email to mpir-devel+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/mpir-devel?hl=en.