Hello, Using MQ-triggering, I start an application on AIX. The application works fine and ends normally some seconds later. All ok so far. BUT: After the application endet, the triggermonitor (runmqtrm) puts the trigger-message into the DLQ with Reason: 265 = MQFB_APPL_CANNOT_BE_STARTET! This makes no sense, since the application has started and ended normally!?!
I know that this reasoncode occurs when the application crashes. But my one was ending ok. Also, in MQ5.1, this problem did not occur. It is new to me in MQ5.3.0.0. But I could not find anything special in the 5.3 manual. - Did I miss some news in the manual? - Possible Bug? - May 5.3.0.1 help? - Any Ideas at all? Thanks! Roland ___________________________________________________________________________ Disclaimer: Diese Mitteilung ist nur fuer die Empfaengerin / den Empfaenger bestimmt. Fuer den Fall, dass sie von nichtberechtigten Personen empfangen wird, bitten wir diese hoeflich, die Mitteilung an die ZKB zurueckzusenden und anschliessend die Mitteilung mit allen Anhaengen sowie allfaellige Kopien zu vernichten bzw. zu loeschen. Der Gebrauch der Information ist verboten. This message is intended only for the named recipient and may contain confidential or privileged information. If you have received it in error, please advise the sender by return e-mail and delete this message and any attachments. Any unauthorised use or dissemination of this information is strictly prohibited. Instructions for managing your mailing list subscription are provided in the Listserv General Users Guide available at http://www.lsoft.com Archive: http://vm.akh-wien.ac.at/MQSeries.archive