> I am expecting much higher values on graphs. > This Interface is supposed to flow at the rate of 1.5 Mb the graphs shows > 300 kb.
> MaxBytes[CISCO]: 150000 150000 is too low for an interface with a T1 on it - remember you divide by 8 not 10. T1 = 1544000 = MaxBytes 193000 It doesn't hurt to leave a little room in MaxBytes especially a link that peaks frequently. I'd use 200000 for this if I were you. MaxBytes is only used, to ignore "glitches" - i.e. make sure you don't get any 8mbps glitches on a T1 due to an erroneous reading. You don't need to (or shouldn't, in my experience) set it to *exactly* the maximum you expect - a little headroom doesn't hurt. Regards Bob -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
