Thanks for the input, Amos. Yes, I did check the Nortel site and came to the same link you pointed out. Unfortunately, I was not able to find any references to SNMP (other than SNMP traps) in these documents. I have contacted our Nortel engineer for further followup on this, but I was hoping it was possible to instruct MRTG to grab the 64-bit counters using SNMP v1.
Russ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Amos Shapira Sent: Wednesday, March 21, 2007 8:26 PM To: [email protected] Subject: Re: [mrtg] 64-bit counters with SNMPv1? On 22/03/07, Forthofer Russ <[EMAIL PROTECTED]> wrote: > is used. However, in this case, v2 is apparently not supported. To > verify this, I entered the following commands: > > snmpget -c commstr -v 2c xx.xx.xx.xx 1.3.6.1.2.1.31.1.1.1.6.17 (response: > Timeout: No Response from xx.xx.xx.xx) > > snmpget -c commstr -v 1 xx.xx.xx.xx 1.3.6.1.2.1.31.1.1.1.6.17 (response: > IF-MIB::ifHCInOctets.17 = Counter64: 6058121224) > > This suggests to me that the box does not support SNMPv2. Is there a > way for me to make use of the 64-bit counters, while using SNMPv1? > (Or if someone knows of a way to enable SNMPv2 on a Nortel OM3500, > that would also be a quite acceptable - perhaps preferable - > solution.) > > Any help would be greatly appreciated. Have you tried to dig Nortetl's web site to confirm this? I'm not an expert but my gut feeling is that anything released in the last decade that already supports SNMP should support version 2c or above. Here is a link to get you started: http://www130.nortelnetworks.com/go/main.jsp?cscat=DOCUMENTATION&poid=89 99 I can't actually download the documents from this page because I don't have Nortel account but you should be able to. (and if not - where are the manuals which arrived with the box?). Cheers, --Amos _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg The information contained in this e-mail and any accompanying documents is intended for the sole use of the recipient to whom it is addressed, and may contain information that is privileged, confidential, and prohibited from disclosure under applicable law. If you are not the intended recipient, or authorized to receive this on behalf of the recipient, you are hereby notified that any review, use, disclosure, copying, or distribution is prohibited. If you are not the intended recipient(s), please contact the sender by e-mail and destroy all copies of the original message. Thank you. _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
