On Tue, 3 Apr 2007, Rohit V Bhute wrote: > john wrote: >> On Tue, 3 Apr 2007, Rohit V Bhute wrote: >> >>> My setup is as follows >>> [PC1]<eth0>----------<ADSL modem DLink GLB-502T> >>> [PC1]<eth1>----------<sometimes connected to PC2 through crossover> >> Er, note that its BYTES per second, not kilo bytes. I.e. a very small >> amount of data.. > > Sorry, that's B/s. But still, if my last recorded speed had been, say > 100KB/s, it would have shown that.
http://oss.oetiker.ch/mrtg/doc/mrtg-reference.en.html One of the options you can set is: unknaszero Log unknown data as zero instead of the default behaviour of repeating the last value seen. Be careful with this, often a flat line in the graph is much more obvious than a line at 0. > And about my second problem? It seems like MRTG has now latched onto > eth1 and the same behavior is being replicated there! Funnily, I'm using > eth0 for connecting to the net. My setup is in a mess! Your interface order may be different, but the way you are referencing them in the target is for example 2:[EMAIL PROTECTED], so its looking for the second interface which may now not be the same as when you set it up. If you look at the reference page I linked above, there are different ways to reference the interface. You can do it by IP, MAC, description and a few others. That might help you get a more static reference to the relevant card your trying to measure. john _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
