Excellent. Glad to hear that it worked. I have been meaning to go and
figure out exactly what is different in the reg config after "load"
(relative to reset). I just have not cycled back to that project yet.
Bryce
aLUNZ Scott wrote:
The voices inside Bryce Himebaugh's head commanded that the following be
written:
I had a similar issue with a DCO cal routine in a msp430-gdb session.
The code worked fine from cold reset, but would get stuck in the cal
routine > in gdb. I found that doing a "monitor reset" after the load
corrected issue.
WOOT! That did the trick. Have immediately ran into another (different)
problem of course, but you get that. Thanks very much for the advice, it is
much appreciated.
aLUNZ
-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://productguide.itmanagersjournal.com/
_______________________________________________
Mspgcc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mspgcc-users
