I've been running FC4 (2.6.13-1) with PVR250 with no problems.
I just installed the HD3000 card (becaue I installed a Zalman fan --
really cuts down on noise!) and rebooted.
I now have no livetv. I checked recent recordings and there are no files
of recent recordings. So, I assume that the tuner is not being
recognized because of the HD3000 just placed in the pc.
You think that might be it?
I checked mythtv-setup and I didn't see anything that changed or corrupted.
I checked modprobe.conf and cx88-blackbird was installed above the ivtv
driver automatically after the first reboot. So, I ran the "extras" from
pcHDTV site which installed: cx88-atsc, cx88-dvb and cx88-risc in
modprobe.conf.
IVTV looks ok, but I don't know if the /dev/video0 is assigned here:
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.0 (tagged release) loading
ivtv: Linux version: 2.6.13-1.1532_FC4 686 REGPARM 4KSTACKS gcc-4.0
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv0: Autodetected WinTV PVR 250 card (iTVC16 based)
ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKB] -> GSI 11 (level,
low) -> IRQ 11
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
: chip found @ 0xc2 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
tveeprom: Hauppauge: model = 32062, rev = B185, serial# = 7366797
tveeprom: tuner = TCL 2002N 6A (idx = 85, type = 50)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = MSP3445 (type = 12)
saa7115 2-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21]
msp34xx: ivtv version
msp34xx: init: chip=MSP3445G-B8, has NICAM support, simple (D) mode,
simpler (G) no-thread mode
msp34xx: $Id$ compiled on: Oct 21 2005 02:12:13
ivtv0: i2c attach to card #0 ok [client=MSP3445G-B8, addr=40]
tda9885/6/7: chip found @ 0x86
ivtv0: loading /lib/modules/ivtv-fw-enc.bin
ivtv0: Encoder revision: 0x02040024
ivtv0 warning: Encoder Firmware can be buggy, use version 0x02040011 or
0x02050032.
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB
total)
ivtv0: Create encoder radio stream
tuner 2-0061: type set to 50 (TCL 2002N)
ivtv0: Initialized WinTV PVR 250, card #0
ivtv: ==================== END INIT IVTV ====================
There is an entry in dmesg of note. It shows the HD3000 at video0. Why
would this be?:
=====================================
Linux video capture interface: v1.00
cx2388x blackbird driver version 0.0.5 loaded
cx88[0]: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV
[card=22,autodetected]
TV tuner 52 at 0x1fe, Radio tuner -1 at 0x1fe
cx2388x v4l2 driver version 0.0.5 loaded
ACPI: PCI Interrupt 0000:00:0b.0[A] -> Link [LNKC] -> GSI 11 (level,
low) -> IRQ 11
cx88[0]: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV
[card=22,autodetected]
TV tuner 52 at 0x1fe, Radio tuner -1 at 0x1fe
cx88[0]/0: found at 0000:00:0b.0, rev: 5, irq: 11, latency: 32, mmio:
0xea000000
: chip found @ 0xc2 (cx88[0])
tuner 1-0061: type set to 52 (Thomson DDT 7610 (ATSC/NTSC))
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
cx88[0]/0: registered device radio0
=================================
Here's relevant info from lsmod:
====================
msp3400 25392 0
saa7115 12816 0
ivtv 227348 0
tuner 37237 0
cx8800 37069 0
v4l1_compat 13637 1 cx8800
v4l2_common 5953 1 cx8800
cx88_blackbird 15045 0
cx8802 15429 1 cx88_blackbird
cx88xx 58209 3 cx8800,cx88_blackbird,cx8802
i2c_algo_bit 9417 2 ivtv,cx88xx
video_buf 26565 4 cx8800,cx88_blackbird,cx8802,cx88xx
ir_common 8389 1 cx88xx
btcx_risc 5065 3 cx8800,cx8802,cx88xx
tveeprom 11985 1 cx88xx
videodev 9921 4 ivtv,cx8800,cx88_blackbird,cx88xx
shpchp 95429 0
i2c_viapro 8529 0
i2c_core 21697 13
it87,eeprom,lm90,i2c_sensor,i2c_isa,tda9887,msp3400,saa7115,tuner,cx88xx,i2c_algo_bit,tveeprom,i2c_viapro
================================
And my modprobe.conf I commented out the cx88 items, but they still
loaded after reboot:
=================================
alias char-major-61 lirc_i2c
alias eth0 via-rhine
alias scsi_hostadapter sata_via
alias snd-card-0 snd-via82xx
options snd-card-0 index=0
options snd-via82xx index=0
remove snd-via82xx { /usr/sbin/alsactl store 0 >/dev/null 2>&1 || : ; };
/sbin/modprobe -r --ignore-remove snd-via82xx
alias usb-controller ehci-hcd
alias usb-controller1 uhci-hcd
alias ieee1394-controller ohci1394
#
# ivtv modules setup
alias char-major-81-0 ivtv
alias tveeprom tveeprom-ivtv
alias msp3400 msp3400-ivtv
#
# cx88 modules
#alias char-major-81 cx88-blackbird
#install cx88-atsc /sbin/modprobe cx8800;/sbin/modprobe --ignore-install
cx88-atsc
#install cx88-dvb /sbin/modprobe cx8800;/sbin/modprobe --ignore-install
cx88-dvb
#install btcx-risc /sbin/modprobe tuner;/sbin/modprobe --ignore-install
btcx-risc
# nvidia kernel module
alias char-major-195 nvidia-1_0-7676
alias nvidia nvidia-1_0-7676
# lirc - at bottom to ensure ivtv is loaded before lirc_i2c
install lirc_i2c /sbin/modprobe ivtv; /sbin/modprobe --ignore-install
lirc_i2c
============================================
any help or pointers to doc much appreciated. I looked thru the archives
and didn't see anything.
brad
_______________________________________________
mythtv-users mailing list
mythtv-users@mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users