On Mon, 2006-01-23 at 21:54 -0700, Nathan A. Smith wrote: > Hi, > > I have setup my myth box (an Athlon 1800+, 756Meg Memory, 100G+ > Harddrive space, nic, and the afore mentioned pvr-500). Everything > seems to run, but I only get static on "Tuner 4" and a very poor picture > (if I get one) on "tuner 6". I have coax and composite cables attached > to the main card, I don't have the daughter card installed. When I look > at "tuner status" it shows: > > tuner 1: not available > tuner 2: not available > tuner 4: not recording > tuner 6: not recording > > I followed the instructions off of mythtv.org and placed to tuner > devices: > > /dev/video0 & /dev/video1 > > I also assigned video sources to both tuners (although there wasn't any > named tuner0 or tuner1 -- just 2 lines of tuner) and both composite > lines (both 0 & 1). > > What else should I be trying? > > Any help would be greatly appreciated > > Nasa
Ok, I figured some log data would be helpful (I hope), so here it is: ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.1 (tagged release) loading ivtv: Linux version: 2.6.12-12mdk 686 gcc-4.0 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18 ACPI: PCI Interrupt 0000:04:08.0[A] -> Link [APC3] -> GSI 18 (level, low) -> IRQ 18 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tveeprom: Hauppauge: model = 23552, rev = D492, serial# = 7814386 tveeprom: tuner = Philips FQ1236A MK4 (idx = 92, type = 57) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3410D (type = 5) ivtv0: This is the first unit of a PVR500 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=60] tuner 0-0060: chip found @ 0xc0 (ivtv i2c driver #0) cx25840 0-0044: ivtv driver cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) cx25840 0-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] wm8775 0-001b: ivtv driver wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] tda9885/6/7: chip found @ 0x86 ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream tuner 0-0060: type set to 57 (Philips FQ1236A MK4) ivtv0: Initialized WinTV PVR 500 (unit #1), card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19 ACPI: PCI Interrupt 0000:04:09.0[A] -> Link [APC4] -> GSI 19 (level, low) -> IRQ 19 ivtv1: Unreasonably low latency timer, setting to 64 (was 32) ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #1) cx25840 1-0044: ivtv driver cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] wm8775 1-001b: ivtv driver wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] tda9885/6/7: chip found @ 0x86 ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] tveeprom: Hauppauge: model = 23552, rev = D492, serial# = 7814386 tveeprom: tuner = Philips FQ1236A MK4 (idx = 92, type = 57) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3410D (type = 5) ivtv1: This is the second unit of a PVR500 ivtv1: Correcting tveeprom data: no radio present on second unit ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02050032 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner 1-0061: type set to 57 (Philips FQ1236A MK4) ivtv1: Initialized WinTV PVR 500 (unit #2), card #1 ivtv: ==================== END INIT IVTV ==================== Nasa > > _______________________________________________ > mythtv-users mailing list > mythtv-users@mythtv.org > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users _______________________________________________ mythtv-users mailing list mythtv-users@mythtv.org http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users