On Wed, Feb 18, 2015 at 08:23:37PM -0500, Rob Seastrom wrote:
>
> "Robert Webb" <rw...@ropeguru.com> writes:
>
> > What I do not like about the Pi is the network port is on the USB
> > bus and thus limited to USB speeds.??
>
> Pretty much all of the ARM boards have their ethernet ports on HSIC
> channels (480mbit/sec, no-transceiver-phy USB for on-board use -
> maximum length is 10cm).
>
Agreed the long pole at a small site for DNS won't be the USB bus. Might I
recommend the following:
odroid-c1 + eMMC module + RTC battery + case + power adapter. Should run you
about $75 *AND*
wouldn't be bad for running NTP as well.
The gig-e port on the C1 has been observed to push 405Mbps TX and 940Mbps+ RX
via iperf.
--
Bryan G. Seitz
