I could use static routes but I noticed since I moved to full routes I have had a lot fewer customer complaints about latency(especially when it comes to Voice and VPN traffic).
I wasn't using per-packet load balancing. I believe juniper default is per IP. My timers are as follows Active Holdtime: 90 Keepalive Interval: 30 Would I be correct in thinking I need to contact my ISP to lower these values? An interesting note is when I had both ISPs connected into a single MX104 the failover was just a few seconds. Thanks again. On Tue, May 15, 2018 at 8:42 PM Ben Cannon <b...@6by7.net> wrote: > Have you checked your timeouts ? > > -Ben > > > On May 15, 2018, at 4:09 PM, Kaiser, Erich <er...@gotfusion.net> wrote: > > > > Do you need full routes? What about just a default route from BGP? > > > > Erich Kaiser > > The Fusion Network > > er...@gotfusion.net > > Office: 815-570-3101 > > > > > > > > > >> On Tue, May 15, 2018 at 5:38 PM, Aaron Gould <aar...@gvtc.com> wrote: > >> > >> You sure it doesn't have something to do with 60 seconds * 3 = 180 secs > of > >> BGP neighbor Time out before it believes neighbor is dead and remove > routes > >> to that neighbor? > >> > >> Aaron > >> > >>> On May 15, 2018, at 9:10 AM, Adam Kajtar <akaj...@wadsworthcity.org> > >> wrote: > >>> > >>> Hello: > >>> > >>> I'm running two Juniper MX104s. Each MX has 1 ISP connected running > >>> BGP(full routes). iBGP is running between the routers via a two port > 20G > >>> lag. When one of the ISPs fails, it can take upwards of 2 minutes for > >>> traffic to start flowing correctly. The router has the correct route in > >> the > >>> routing table, but it doesn't install it in the forwarding table for > the > >>> full two mins. > >>> > >>> I have a few questions if anyone could answer them. > >>> > >>> - What would a usual convergence time be for this setup? > >>> - Is there anything I could do speed this process up? (I tried > >> Multipath) > >>> - Any tips and tricks would be much appreciated > >>> > >>> Thanks in Advance > >>> -- > >>> Adam Kajtar > >>> Systems Administrator > >>> City of Wadsworth > >>> akaj...@wadsworthcity.org > >>> ----------------------------------------------------- > >>> http://www.wadsworthcity.com > >>> > >>> Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter > >>> <https://twitter.com/CityOfWadsworth> *|* Instagram > >>> <https://www.instagram.com/cityofwadsworth/> *|* YouTube > >>> <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ> > >> > >> > -- Adam Kajtar Systems Administrator, Safety Services City of Wadsworth Office 330.335.2865 Cell 330.485.6510 akaj...@wadsworthcity.org ----------------------------------------------------- http://www.wadsworthcity.com Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter <https://twitter.com/CityOfWadsworth> *|* Instagram <https://www.instagram.com/cityofwadsworth/> *|* YouTube <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ>