Erich, Good Idea. I can't believe I didn't think of that earlier. Simple and effective. I will go ahead and request the defaults from my ISP and update the thread of the findings.
Thanks! On Wed, May 16, 2018 at 10:03 AM Kaiser, Erich <er...@gotfusion.net> wrote: > A last resort route (default route) could still be good to take from your > ISP(s) even if you still do full routes, as the propagation is happening on > the internet side, you should at least have a path inbound through the > other provider. The default route at least would send the traffic out if > it does not see the route locally. Just an idea. > > > > On Wed, May 16, 2018 at 8:22 AM, Adam Kajtar <akaj...@wadsworthcity.org> > wrote: > > > I could use static routes but I noticed since I moved to full routes I > > have had a lot fewer customer complaints about latency(especially when it > > comes to Voice and VPN traffic). > > > > I wasn't using per-packet load balancing. I believe juniper default is > per > > IP. > > > > My timers are as follows > > Active Holdtime: 90 > > Keepalive Interval: 30 > > > > Would I be correct in thinking I need to contact my ISP to lower these > > values? > > > > An interesting note is when I had both ISPs connected into a single MX104 > > the failover was just a few seconds. > > > > Thanks again. > > > > > > > > On Tue, May 15, 2018 at 8:42 PM Ben Cannon <b...@6by7.net> wrote: > > > >> Have you checked your timeouts ? > >> > >> -Ben > >> > >> > On May 15, 2018, at 4:09 PM, Kaiser, Erich <er...@gotfusion.net> > wrote: > >> > > >> > Do you need full routes? What about just a default route from BGP? > >> > > >> > Erich Kaiser > >> > The Fusion Network > >> > er...@gotfusion.net > >> > Office: 815-570-3101 > >> > > >> > > >> > > >> > > >> >> On Tue, May 15, 2018 at 5:38 PM, Aaron Gould <aar...@gvtc.com> > wrote: > >> >> > >> >> You sure it doesn't have something to do with 60 seconds * 3 = 180 > >> secs of > >> >> BGP neighbor Time out before it believes neighbor is dead and remove > >> routes > >> >> to that neighbor? > >> >> > >> >> Aaron > >> >> > >> >>> On May 15, 2018, at 9:10 AM, Adam Kajtar <akaj...@wadsworthcity.org > > > >> >> wrote: > >> >>> > >> >>> Hello: > >> >>> > >> >>> I'm running two Juniper MX104s. Each MX has 1 ISP connected running > >> >>> BGP(full routes). iBGP is running between the routers via a two port > >> 20G > >> >>> lag. When one of the ISPs fails, it can take upwards of 2 minutes > for > >> >>> traffic to start flowing correctly. The router has the correct route > >> in > >> >> the > >> >>> routing table, but it doesn't install it in the forwarding table for > >> the > >> >>> full two mins. > >> >>> > >> >>> I have a few questions if anyone could answer them. > >> >>> > >> >>> - What would a usual convergence time be for this setup? > >> >>> - Is there anything I could do speed this process up? (I tried > >> >> Multipath) > >> >>> - Any tips and tricks would be much appreciated > >> >>> > >> >>> Thanks in Advance > >> >>> -- > >> >>> Adam Kajtar > >> >>> Systems Administrator > >> >>> City of Wadsworth > >> >>> akaj...@wadsworthcity.org > >> >>> ----------------------------------------------------- > >> >>> http://www.wadsworthcity.com > >> >>> > >> >>> Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter > >> >>> <https://twitter.com/CityOfWadsworth> *|* Instagram > >> >>> <https://www.instagram.com/cityofwadsworth/> *|* YouTube > >> >>> <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ> > >> >> > >> >> > >> > > > > > > -- > > Adam Kajtar > > Systems Administrator, Safety Services > > City of Wadsworth > > Office 330.335.2865 > > Cell 330.485.6510 > > akaj...@wadsworthcity.org > > ----------------------------------------------------- > > http://www.wadsworthcity.com > > > > Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter > > <https://twitter.com/CityOfWadsworth> *|* Instagram > > <https://www.instagram.com/cityofwadsworth/> *|* YouTube > > <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ> > > > -- Adam Kajtar Systems Administrator, Safety Services City of Wadsworth Office 330.335.2865 Cell 330.485.6510 akaj...@wadsworthcity.org ----------------------------------------------------- http://www.wadsworthcity.com Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter <https://twitter.com/CityOfWadsworth> *|* Instagram <https://www.instagram.com/cityofwadsworth/> *|* YouTube <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ>
