I just want to establish some serial communication between my computer and a PIC controller. Like David mentioned, RS232 is actually +/- 10V rather than +/- 5V. The levels directly from controller are obviously only 0V and 5V. Now I am thinking, for the Rx input this is not a problem because it will easily handle the +/- 10V input signals if I add a series resistor. But the Tx output needs to go from 0V/5V to +/- 10V which is normally done with a MAX232 for example. The MAX has 4 line converters (2 input; 2 output) but I only need 1 for my Tx signal. So I was after something smaller like an 8 pin or even a 5 pin driver that works on just a +5V supply.
Michel On Aug 24, 5:43 pm, Dalibor Farný <dali...@farny.cz> wrote: > Hello, look on rs485. I played with it a lot, ready to answer Your > questions :-) it works for long distances and allows more devices on one > line (bus). > > Try to describe your devices more.. > > Dalibor Farnýhttp://dalibor.farny.cz > > sent from Samsung Galaxy Pad > Dne 24.8.2012 7:46 "Michel" <mic...@xiac.com> napsal(a): > > > > > > > > > I am after a driver like the MAX232 that has 5V levels on one side; > > +/- 5 on the other side and only requires a +5V supply. The MAX232 > > however is a 16 pin device and I am looking for something smaller (8 > > pins). I only need one Rx and one Tx channel. > > > I am also thinking, maybe I don't need one and just use 0V and 5V > > levels rather than -5V and +5V, but not sure if that will work. > > > Anybody knows more about that? > > > Michel > > > -- > > You received this message because you are subscribed to the Google Groups > > "neonixie-l" group. > > To post to this group, send an email to neonixie-l@googlegroups.com. > > To unsubscribe from this group, send email to > > neonixie-l+unsubscr...@googlegroups.com. > > For more options, visithttps://groups.google.com/groups/opt_out. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to neonixie-l@googlegroups.com. To unsubscribe from this group, send email to neonixie-l+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/groups/opt_out.