Have you looked to see if you can buy brass tube stock? Here's some I found in a few minutes -
https://www.onlinemetals.com/merchant.cfm?pid=19814&step=4&showunits=inches&id=84&top_cat=79 It's 25 thousandths oversize outside diameter but precisely right inside. You need about seven inches, allowing for waste. Now this is of course in the USA and we've never heard of that metric hooha, but if you look I'm sure someone in Europe must sell brass tube with 15mm OD and 3mm walls. You can clean out 0.5mm inside with a drill more easily than you can turn down the outside, then cut it into 7mm lengths with a pipe cutter or even a hacksaw. If you want, I can buy this stuff and make them for you. On Wednesday, February 4, 2015 at 8:30:48 AM UTC-8, Paul Parry wrote: > > Hi Guys, > > Anyone suggest where I can get some little spacers made ( brass preferably > ) I need 15mm O/D with a 9.5mm I/D hole and 7mm in height. They are to > allow me to fit some little glass tubes that hold little Neon colon > indicators into some regular 15mm copper pipe fittings. > It would take someone with a lathe about half an hour, but it isn't > something I have. I would need 20 of them and clean out of ideas. One > engineering company quoted me a 3 figure price just to set a lathe up :( > > Kind regards, > Paul > > -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to neonixie-l+unsubscr...@googlegroups.com. To post to this group, send an email to neonixie-l@googlegroups.com. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/7685f149-1dcf-4a8e-a1e1-31c7bd443b3b%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
