If I were you, I woiuld have tried the live image with dhcpcd enabled (+ sshd etc. ), you should be able to get your IP address from the dhcp server. Just in case, I'd gone with -current as well.
On Sun, 30 Dec 2018 at 15:59, J. Lewis Muir <[email protected]> wrote: > > I'm trying to install NetBSD 8 on a PC Engines apu2d4 > > https://www.pcengines.ch/apu2d4.htm > > via a USB thumb drive with a NetBSD 8 install image > > > https://cdn.netbsd.org/pub/NetBSD/NetBSD-8.0/images/NetBSD-8.0-amd64-install.img.gz > > via a serial console where I can get to the welcome screen of the > installer image > > Welcome to the NetBSD/amd64 8.0 installation image > > =============================================================================== > > ACPI (Advanced Configuration and Power Interface) should work on all modern > and legacy hardware. However if you do encounter a problem while booting, > try disabling it and report a bug at http://www.NetBSD.org/. > > 1. Install NetBSD > 2. Install NetBSD (no ACPI) > 3. Install NetBSD (no ACPI, no SMP) > 4. Drop to boot prompt > > Choose an option; RETURN for default; SPACE to stop countdown. > Option 1 will be chosen in 0 seconds. > > Option: [1]: > > and I press Space and then Enter to start the install, and it shows > some numbers with a spinner and then shows > > 18010904+813996+1283156 [1191264+821120+12847- > > but then the screen goes blank. > > Does anyone know what I can try to get this to work? > > I tried the "no ACPI" and "no ACPI, no SMP" install choices, but that > didn't help. > > The apu2d4 says the serial port baud rate is 115200 which is what I > successfully used to communicate with the apu2d4. Will the boot image > kernel work with this baud rate? If not, is there a way to change it > by dropping to the boot prompt? Or do I need to build a custom kernel > with the baud rate set to 115200? > > Thank you! > > Lewis -- ----
