On Fri, Jan 27, 2017 at 03:42:05PM +0300, Sergei Shtylyov wrote:
> Hello!
>
> On 01/27/2017 02:04 PM, Simon Horman wrote:
>
> >From: Kazuya Mizuguchi <kazuya.mizuguchi...@renesas.com>
> >
> >This patch enables tx and rx clock internal delay modes (TDM and RDM).
> >
> >This is to address a failure in the case of 1Gbps communication using the
> >by salvator-x board with the KSZ9031RNX phy. This has been reported to
> >occur with both the r8a7795 (H3) and r8a7796 (M3-W) SoCs.
> >
> >With this change APSR internal delay modes are enabled for
> >"rgmii-id", "rgmii-rxid" and "rgmii-txid" phy modes as follows:
> >
> >phy mode | ASPR delay mode
> >-----------+----------------
> >rgmii-id | TDM and RDM
> >rgmii-rxid | RDM
> >rgmii-txid | TDM
> >
> >Signed-off-by: Kazuya Mizuguchi <kazuya.mizuguchi...@renesas.com>
> >Signed-off-by: Simon Horman <horms+rene...@verge.net.au>
> >
> >---
> >v1 [Simon Horman]
> >- Combined patches
> >- Reworded changelog
> >
> >v0 [Kazuya Mizuguchi]
> >---
> > drivers/net/ethernet/renesas/ravb.h | 10 ++++++++++
> > drivers/net/ethernet/renesas/ravb_main.c | 29 +++++++++++++++++++++++++++++
> > 2 files changed, 39 insertions(+)
> >
> >diff --git a/drivers/net/ethernet/renesas/ravb.h
> >b/drivers/net/ethernet/renesas/ravb.h
> >index f1109661a533..d7c91d48cc48 100644
> >--- a/drivers/net/ethernet/renesas/ravb.h
> >+++ b/drivers/net/ethernet/renesas/ravb.h
> [...]
> >@@ -248,6 +249,15 @@ enum ESR_BIT {
> > ESR_EIL = 0x00001000,
> > };
> >
> >+/* APSR */
> >+enum APSR_BIT {
> >+ APSR_MEMS = 0x00000002,
>
> Not documented in the revision 0.5 of the gen3 manual...
It is in version 0.53 of the documentation but I think it can be dropped
from this patch as its unused.
> >+ APSR_CMSW = 0x00000010,
I think the above can also be dropped as it is unused.
> >+ APSR_DM = 0x00006000,
>
> ... and neither this field. Are these documented in the latter revs?
This one is not. I can ask Mizuguchi-san to confirm it exists (with himself).
> >+ APSR_DM_RDM = 0x00002000,
> >+ APSR_DM_TDM = 0x00004000,
> >+};
> >+
> > /* RCR */
> > enum RCR_BIT {
> > RCR_EFFS = 0x00000001,
> >diff --git a/drivers/net/ethernet/renesas/ravb_main.c
> >b/drivers/net/ethernet/renesas/ravb_main.c
> >index 89ac1e3f6175..9fb4c04c5885 100644
> >--- a/drivers/net/ethernet/renesas/ravb_main.c
> >+++ b/drivers/net/ethernet/renesas/ravb_main.c
> >@@ -1904,6 +1904,29 @@ static void ravb_set_config_mode(struct net_device
> >*ndev)
> > }
> > }
> >
> >+static void ravb_set_delay_mode(struct net_device *ndev)
> >+{
> >+ struct ravb_private *priv = netdev_priv(ndev);
> >+
> >+ if (priv->chip_id != RCAR_GEN2) {
> >+ switch (priv->phy_interface) {
> >+ case PHY_INTERFACE_MODE_RGMII_ID:
> >+ ravb_modify(ndev, APSR, APSR_DM, APSR_DM_RDM |
> >+ APSR_DM_TDM);
> >+ break;
> >+ case PHY_INTERFACE_MODE_RGMII_RXID:
> >+ ravb_modify(ndev, APSR, APSR_DM, APSR_DM_RDM);
> >+ break;
> >+ case PHY_INTERFACE_MODE_RGMII_TXID:
> >+ ravb_modify(ndev, APSR, APSR_DM, APSR_DM_TDM);
> >+ break;
> >+ default:
> >+ ravb_modify(ndev, APSR, APSR_DM, 0);
> >+ break;
> >+ }
>
> How about doing ravb_modify() only once?
Something like this?
int set = 0;
if (priv->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
priv->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID)
set |= APSR_DM_RDM;
if (priv->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
priv->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID)
set |= APSR_DM_TDM;
ravb_modify(ndev, APSR, APSR_DM, set);
I don't really see any advantage to it but I can change things around
however you like.
