I have decided that most likely LANstar is a hoe-dunk poe-dunk company and
doesn't support linux. So I put in my other NIC, a 3com 3c900 "Boomarang".
Now I found the source drivers for it and compiled and installed the
module. But I don't know where to go from here, I dont' know how to see if
the module itself is working. I am taking that it is not, due tot he fact
that the network light on the hub isn't turned out. I do however see the
card as a device my bios picks up when I restart my computer. It is a PCI,
10Mb/s card. Yet again, any and all help would be much appreciated. Thanks.
>You will most likely need to compile a modual for linux. Go to the
>LANstar site and check to see if they support linux. Or you can look
>on your install disk. I am not familiar with LANStar, but not all of
>the makers support linux. You will have to check with the maker.
>Or alternately purchase a lan card for whom there is support provided
>with linux.
>
> Dennis
>
-------------------------
Signed,
Bob 'Reveral' Bonifield
[EMAIL PROTECTED]
Fraggin' in the Heartland
http://lan.quakecity.net/
