On Friday 20 June 2003 09:07, H.J.Bathoorn wrote: > On Friday 20 June 2003 05:23, revolt wrote: > > Charles A Edwards wrote: > > >On Thu, 19 Jun 2003 21:05:02 -0600 > > > > > >revolt <[EMAIL PROTECTED]> wrote: > > >>Couldn't load PyQT module! Check it's installed properly. > > > > > >Do you have PyQt installed? > > > > > > > > > Charles > > > > urpmi installed PyQt-3.5-1.mdk for me. I have been looking for a newer > > version without any luck so far. I checked the frequent problems page > > which wasn't much help (I do not want to compile it from source if > > possible, since I have rarely had much luck compiling stuff in the past.) > > > > Have you had any luck with this software under mdk 9.1? Has anyone else > > who might be reading this? > > Where did you get the quickrip.rpm? > > I couldn't find one......quickrip will not install (using the install.sh)on > my machine stating that PyQt isn't installed. Of course it is installed and > so are libsip and sip:o( > The error messages are the same as yours though.....boiling down to the > (python)module libsip not being found. > Checking the python modules [go into the python shell; type "help" and then > "modules()", which will give you a list of all available modules] there > indeed isn't a libsip module on my machine. > > Personally I don't have any time available right now (got to make a living) > but methinks you (and me) should be checking the libsip installation. > > Frankly I thought libsip were only libraries, not modules. > > Anybody any wiser comments?? > > Good luck, > HarM
Found it: install libsip9-devel! HTH, HarM
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com