On Sun, 14 Mar 2004 18:32:03 +0700 [EMAIL PROTECTED] wrote: > Quoting "Troy T. Hall" <[EMAIL PROTECTED]>: > > Not listed as /dev/sda1? Strange. > However, you can watch what is happening by doing: > tail -f /var/log/messages when you plug-in the camera. > > > > Mar 14 09:36:35 localhost kernel: usb 1-1: new full speed USB device using address 4 Mar 14 09:36:36 localhost kernel: scsi1 : SCSI emulation for USB Mass Storage devices Mar 14 09:36:36 localhost kernel: Vendor: Fujifilm Model: FinePix 1400Zoom Rev: 1000 Mar 14 09:36:36 localhost kernel: Type: Direct-Access ANSI SCSI revision: 02 Mar 14 09:36:36 localhost modprobe: FATAL: Module scsimon not found. Mar 14 09:36:36 localhost modprobe: FATAL: Module scsimon not found. Mar 14 09:36:42 localhost kernel: sda : READ CAPACITY failed. Mar 14 09:36:42 localhost kernel: sda : status=0, message=00, host=7, driver=00 Mar 14 09:36:42 localhost kernel: sda : sense not available. Mar 14 09:36:42 localhost kernel: sda: assuming Write Enabled Mar 14 09:36:42 localhost kernel: sda: assuming drive cache: write through Mar 14 09:36:42 localhost kernel: sda : READ CAPACITY failed. Mar 14 09:36:42 localhost kernel: sda : status=0, message=00, host=7, driver=00 Mar 14 09:36:42 localhost kernel: sda : sense not available. Mar 14 09:36:42 localhost kernel: sda: assuming Write Enabled Mar 14 09:36:42 localhost kernel: sda: assuming drive cache: write through Mar 14 09:36:42 localhost kernel: sda : READ CAPACITY failed. Mar 14 09:36:42 localhost kernel: sda : status=0, message=00, host=7, driver=00 Mar 14 09:36:42 localhost kernel: sda : sense not available. Mar 14 09:36:42 localhost kernel: sda: assuming Write Enabled Mar 14 09:36:42 localhost kernel: sda: assuming drive cache: write through Mar 14 09:36:42 localhost kernel: /dev/scsi/host1/bus0/target0/lun0:<3>Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 262143 Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 262143 Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost kernel: ldm_validate_partition_table(): Disk read failed. Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost kernel: unable to read partition table Mar 14 09:36:42 localhost kernel: /dev/scsi/host1/bus0/target0/lun0:<3>Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost Buffer I/O error on device sda, logical block 262143 Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost kernel: ldm_validate_partition_table(): Disk read failed. Mar 14 09:36:42 localhost kernel: Buffer I/O error on device sda, logical block 0 Mar 14 09:36:42 localhost kernel: unable to read partition table Mar 14 09:36:42 localhost kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 Mar 14 09:36:42 localhost kernel: Attached scsi generic sg0 at scsi1, channel 0, id 0, lun 0, type 0 Mar 14 09:36:43 localhost scsi.agent[10473]: disk at /devices/pci0000:00/0000:00:04.2/usb1/1-1/1-1:1.0/host1/1:0:0:0
so is the important line the modprobe:FATAL one? This is a bit over my head. if it can't find the module how do i tell it where to find it / where do i look for it? thanks. it looks like it's trying to attach it at /dev/sda but I get [EMAIL PROTECTED] dev]# cat sda cat: sda: Input/output error Someone mentioned hotplug... hotplug is installed and running. I tried locate scsimon (yep.. i ran updatedb first) but it didn't return anything. Any suggestions?
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com