On Mon, 01 Nov 1999, you wrote:
> I am attempting to set up a server using ip masq connecting a mixed
> linux/win 98 and nt network to a cable modem. The system works using
> Win2000 as server, but I have been unable to get linux to recognize more
> than one of the ethernet cards.
>
> The system is a AMD K6-2 350 with 64 MB of RAM, the cable modem is
> connected to a 3c509b, and local network is connected to a Genius
> (Realtek) card. Upon setup the realtek driver is loaded as eth0 (found
> by the system PCI probe). I have attempted to setup the 3c509b with a
> line in lilo.conf, listing IRQ and address, without success. I have also
> tried listing the card in the networking section of linuxconf with the
> same information, also without success.
>
> How can I get linux to recognize and load both cards?
>
I think there MAY be newer drivers for the 3Com, Or, you may need to
boot to DOS and use the 3Com setup util to make sure Plug -n- Pray is
turned off on that card.
John
