Asa Rossoff said:
> JoeHill <[EMAIL PROTECTED]> said:
> > I'm not sure it's the value I'm using, since I tried changing it to
vga=791
> > to no avail. Isn't there some need to have the nvidia module loaded at
first
> > boot for framebuffer mode to work?
> >
> > Would it make a difference using the decimal value vs. the other?
>
> I was disappointed to find only a minimal set of very low-res framebuffer
> modes listed on my system, too, so if there's some solution I'm certainly
> interested.
>
> I'm using a different video card -- 3D Labs Permedia 2 -- and after
> discovering that Xfree 4.x drivers for this card don't work, I didn't even
> bother to ask anyone why the kernel doesn't seem to support it....
Although,
> in fact, some very old Ms-dos programs that set various vesa modes without
> any special drivers work brilliantly.

I just did a search and saw that there were some solutions to this issue
posted on the mandrake-expert list, although Joe wasn't able to get a
workable setup.

For the record:
1) vga=ASK in lilo.conf does not always list every available mode.  e.g.
vga=788 (800x600x16) was available on Joe's system, although it wasn't
listed.

2) There are some good how-to guides about setting up framebuffer, including
idiosyncracies with various cards and configurations:
http://www.digitalhermit.com/linux/hiresconsole.html and
http://www.tldp.org/HOWTO/Framebuffer-HOWTO-5.html

3) The first of those how-tos also gives instructions for setting up
SVGATextMode instead of using the kernel framebuffer driver.

4) Both how-tos talk about the need to rebuild the kernel to support various
video cards that the default vesafb kernel driver doesn't support.


This is what I understood from those sources, anyway.  I'm a newbie, though
:-)   It looks like there is specific support for my video card, so
hopefully I'll get that going.

Asa


____________________________________________________
Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com
Join the Club : http://www.mandrakeclub.com
____________________________________________________

Reply via email to