Joe:
I hit a brick wall trying to run the 3CCFE575BT 10/100 MHz card in my
solo2500. I could not ping any address outside my gateway. I then got
another PCMCIA card (3C589D-TP), and it flew! Worked like a champ. It
turns out the 3CCFE575BT was marginally supported.
I bet your 3c575 is in the same boat!
Rick Bonczek
LAN Administrator (sorry to say windows only!)
[EMAIL PROTECTED]
[EMAIL PROTECTED]
----- Original Message -----
From: Joe Brault <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, December 27, 1999 1:54 PM
Subject: [newbie] pcmcia help needed
> Hello all,
>
> I am in desprate need of help. I am trying to get my gateway solo 2500 on
> the internet, via my pcmcia modem (xircom credit card modem (cm-56t)). I
> have cardmgr installed, and all the necessary pcmcia software ( I think)
but
> I can't get linux to recognize my card. When I insert my card, I hear one
> high beep, followed by a low one, and my modem is configured as a memory
> card. Anyone know why this would be? I am greatly confused by this. I
> have tried a variety of things, but to no avail.
>
> I also am trying to get my 3com network card to work. This card is
> recognized by linux, but i get this error in my log when I insert it:
>
> localhost kernel: cs: could not allocate 136k memory for cardbus
> socket1
>
> 3c575_cb: Request IO: out of resources
>
> I am unsure of how to reallocate the memory for this card... I tried what
> was mentioned in the pcmcia howto, but this did not help. I appreciate
any
> and all help with this matter, I am growing quite frustrated. Thanks in
> advance for your time!
>
>
> Joe :)
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>
