What version of Mandrake are you using, and is this a fresh installation? I have two PRO/100+ cards in my Linux box. They were detected on installation of Linux. You probably need to configure eth0. I prefer the command line stuff, so I would (as root) run linuxconf Select -> Networking ->Basic Host Information Make sure "Enabled" has an X in it. Make sure Net device is eth0 Set kernel module to eepro100 Try that. Bryan Michael Haney <[EMAIL PROTECTED]> on 03/01/2000 11:58:00 AM Please respond to [EMAIL PROTECTED] To: [EMAIL PROTECTED] cc: (bcc: Bryan Moorehead/Link/Allied Holdings) Subject: [newbie] Ethernet Card Problem... ---------- Hi all! I really love Linux-Mandrake, I used to use RedHat 6.1, but this distribution is so much better. ---------- I am having a trouble with my Intel PRO/100+ Management Adapter, its a 10/100Mb ethernet card with a feature that allows a remote server boot the system via a cable connected from the NIC to the motherboard. I downloaded the Linux drivers for the card from www.intel.com and followed the instructions to install the drivers. ---------- What I did was... Extracted the files... Ran make Ran isnmod <modulename> Ran make install Ran Modprobe <modulename> and got no errors. When I boot I get a 'failed' message when eth0 is being initialized. The module appears in the config files but so does the other module the system ASSUME the card was the first time I install it. ---------- Can anyone please help? So sayth the Zorch! The-Zorch Sci-Fi & Fantasy Ezine << Under Development >> http://www.the-zorch.com I Internet Authors Visit the site and sign up!!!
Hi all!
I really love Linux-Mandrake, I used to use RedHat 6.1, but this distribution is so much better.
I am having a trouble with my Intel PRO/100+ Management Adapter, its a 10/100Mb ethernet card with a feature that allows a remote server boot the system via a cable connected from the NIC to the motherboard. I downloaded the Linux drivers for the card from www.intel.com and followed the instructions to install the drivers.
What I did was...
Extracted the files...
Ran make
Ran isnmod <modulename>
Ran make install
Ran Modprobe <modulename>
and got no errors.
When I boot I get a 'failed' message when eth0 is being initialized.
The module appears in the config files but so does the other module the system ASSUME the card was the first time I install it.
Can anyone please help?
So sayth the Zorch!
The-Zorch Sci-Fi & Fantasy Ezine
<< Under Development >>
http://www.the-zorch.com
I Internet Authors
Visit the site and sign up!!!