1) try insmod /lib/mod*/2*/net/ne2000
if you dont get an error message then try
modprobe ne2000
you should see something like this
eth0      Link encap:Ethernet  HWaddr 00:E0:29:2E:AA:27
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          Interrupt:10 Base address:0xb800

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:3924  Metric:1
          RX packets:38727 errors:0 dropped:0 overruns:0 frame:0
          TX packets:38727 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0

if that all works you can take an easy route and use linuxconf to add
the mod for eth0
1) linuxconf
2) networking
3) Basic Host Information
4) hit the tab key until your in the Kernel Module field
4a) press ctrl-x
4b) select ne2000
5) if your useing dhcp select dhcp
6) Enabled
7) tab to accept (hit return)
8) tab to quit (hit return)
9) tab to quit (hit return)
10) Select Activate changes (hit return)
11) tab to quit (hit return)

now you can type ifconfig -a and now the above eth0 should look
something like:
eth0      Link encap:Ethernet  HWaddr 00:E0:C5:F4:08:3A
          inet addr:24.161.66.121  Bcast:24.161.67.255 
Mask:255.255.252.0
          UP BROADCAST NOTRAILERS RUNNING  MTU:1500  Metric:1
          RX packets:70757 errors:0 dropped:0 overruns:0 frame:0
          TX packets:51835 errors:0 dropped:0 overruns:0 carrier:0
          collisions:931 txqueuelen:100
          Interrupt:9 Base address:0xb400
if the eth0 looks like the one after the insmod/modprobe above type
ifup eth0 and then ifconfig -a

Ron


3) 
Peter Hecht wrote:
> 
> Hello,
> 
> I have just installed LM6.1.  I was not able to get my Allied
> Telesyn AT1510 Ethernet Adapter installed.  This is a problem.
> 
> I would like to get the card recognized.  It is an NE2000
> compatible card, but that selection on the install was not
> recognized.  So, I am hoping I will be able to patch my install
> to "see" the NIC.
> 
> Thanks,
> 
> __________________________________________________
> Do You Yahoo!?
> Talk to your friends online with Yahoo! Messenger.
> http://im.yahoo.com

Reply via email to