Yes I have run sndconfig, it identifies it as Ensoniq Es1371 but you never
hear the sample.I checked to see if module "emu10k1" was installed and it
was, also checked module "es1371". After rereading the "howto's " I did a
cat /dev/sndstat and it said no device. How do I link this to the kernel?
Thanks,
Bob
Also did a complete new install enabling PnP os in the bios, didn't help.
----- Original Message -----
From: bluebottle <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, March 16, 2000 4:57 PM
Subject: Re: [newbie] SB PCI 128 Sound Card
> On Wed, 15 Mar 2000, you wrote:
> >
> > I can't get this card to work in MD 7.0. According to the "howto's" this
card is supposed
> to be supported. Using Lothar the card is identified as Ensoniq ES1371.
All
> of the settings use -1 and don't offer any other settings. Testing the
card in
> Lothar locks up the computer. Trying to use other cards settings just says
that
> the device or resource is busy. During boot I can see where it loads the
sound
> module. What do I need to do? Any help appreciated.
>
> I'm running this card in my two linux machines. One is running under
Mandrake
> 7.02 and the other under RH 6.1. Have you run sndconfig as card was
detected
> automatically.
>
> -
> Regards
>
> John the Nadger
>
> http://mklinux.cjb.net
>
> http://www.nadger.uklinux.net
>
>
>
