[EMAIL PROTECTED] wrote:
> Ok, I'm playing w/ X config stuff, and found a neat util that directly reads my
> settings from the monitor.
>
> But when I put the generated modelines into XF86Config it errors out when I
> start an x server saying the dotclodk is too high. So where in h**l do I
> change the maximum dotclock?
>
> I can't just run xf86config b/c it locks up my scsi card, and I use a scsi hd
> as my /.
>
> Any ideas appreciated.
Check SuperProbe, all lowercase except the S and P, which are capital or
uppercase.
There's a man page for this tool, which you should read, first.
man SuperProbe
mike
