|
well when you boot or are
installing....
type linux ide2=0xd800 for example...
----- Original Message -----
Sent: Tuesday, May 30, 2000 7:06 AM
Subject: Re: [newbie] UDMA/66
well thanks and where should i enter
it???
----- Original Message -----
Sent: Tuesday, May 30, 2000 11:50
AM
Subject: Re: [newbie] UDMA/66
well take the input/output range, the first
listed of the controller that is connected with your harddrive
and take that address
----- Original Message -----
Sent: Sunday, May 28, 2000 4:48
PM
Subject: Re: [newbie] UDMA/66
where to see that address?
in 'system' of windows i can only see some
i/o and memory addresses for U66 controller but i don't know what address
to use... there is a lot of them
----- Original Message -----
Sent: Monday, May 29, 2000 12:18
PM
Subject: Re: [newbie] UDMA/66
well linux can use your drive without
drivers for UDMA/66 controllers ass well... If you have a harddrive on a
standrard ide controller and one on your ata66 controller just like
me
and that ata66 drive is at address 0xd800
(look in your windows config) then type at installing ide2=0xd800 and it
works fine without special drivers
----- Original Message -----
Sent: Sunday, May 28, 2000 12:42
AM
Subject: [newbie] UDMA/66
Hi!
I have ony found a UDMA/66 Driver at
promise.com for Linux RedHat.
But how to make Linux Mandrake 7.0
recognizing my Ultra66 controller?
And why doesn't W98 need to recognize it
even without any drivers?
The same at DOS. It needs
nothing...
W2000 has the UDMA/66 Driver, Linux
doesn't...
WHY?
|
