Same problems I am having... HMMM>>> Can anyone say rushed release? > ** Original Subject: RE: [newbie] netgear ea201 stopped working in 7.2? > ** Original Sender: bascule <[EMAIL PROTECTED]> > ** Original Date: Fri, 24 Nov 2000 19:33:29 -0600 > ** Original Message follows... > > i have the above card in my box, under lm7 and 7.1 it worked fine but now > i've installed 7.2 i cannot get get the card to initialise, i have not > changed the cards internal settings (full duplex non pnp) i have entered the > io and irq in the linuxconf>networking>network devices section but when i run > ifup eth0 or when the machine boots the error message 'delaying eth0 > initialisation' comes up, i'm sure the card is fine and i have just missed > out a simple step, but lms 7 and 7.1 were so simple hardware wise that i'm > not aware of what else i should be looking at, what are the services needed > to get the card working (as opposed to actual network service like nfs etc.) > > bascule >** --------- End Original Message ----------- ** > ]XAN[animalTK