in a desperate attempt to get the card to work i decided to compile a new
kernel and now i'm ready to atke an axe to my box.
after running make xconfig and make dep i run make make bzImage, but, there
is no image file or vmlinuz produced as a result, i searced the whole disk
but couldn't find them - aaahhhhh!
please tell me that one can compile with 7.2, on second thoughts tell me one
can't then i'll know that the world isn't just out to get me!
i don't even know what question to ask now!
bascule
On Saturday 25 November 2000 5:10 am, you wrote:
> Same problems I am having... HMMM>>> Can anyone say rushed release?
>
> > ** Original Subject: RE: [newbie] netgear ea201 stopped working in 7.2?
> > ** Original Sender: bascule <[EMAIL PROTECTED]>
> > ** Original Date: Fri, 24 Nov 2000 19:33:29 -0600
> >
> > ** Original Message follows...
> >
> >
> > i have the above card in my box, under lm7 and 7.1 it worked fine but now
> > i've installed 7.2 i cannot get get the card to initialise, i have not
> > changed the cards internal settings (full duplex non pnp) i have entered
> > the io and irq in the linuxconf>networking>network devices section but
> > when i run ifup eth0 or when the machine boots the error message
> > 'delaying eth0 initialisation' comes up, i'm sure the card is fine and i
> > have just missed out a simple step, but lms 7 and 7.1 were so simple
> > hardware wise that i'm not aware of what else i should be looking at,
> > what are the services needed to get the card working (as opposed to
> > actual network service like nfs etc.)
> >
> > bascule
> >
> >
> >** --------- End Original Message ----------- **
>
> ]XAN[animalTK
