On Sunday 24 April 2005 07:36 pm, Rosemary McGillicuddy wrote:
Rosemary, I have not kept up on this thread, but, did you check "enable acpi" on boot up in lilo. If not give it a try, all of my usb devices worked after I enabled acpi. HTH
How do I go about that? I've used mc to look at lilo.conf, is that the one? There are a couple of entries that have acpi in them, but nothing which obviously (to me) says enable, or not.
Thanks
I know you are trying to get a handle on the cli thing, but I am not to well versed in it. I would use mcc and boot then "set up how the system boots" and put an x in "enable acpi" box. In lilo it should show as something like acpi=yes or similar. HTH
After my last message I went to MCC and checked the "enable acpi box". Tried the reader in every usb port, and looked at usbview, still nothing. Tried lsusb, just to be absolutely sure - still nothing. <sigh>
-- Rosemary
Registered Linux User # 386597 http://counter.li.org "A friend may well be a masterpiece of nature". Emerson
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
