On Fri, 2003-09-19 at 09:53, Michael Halcrow wrote: > On Fri, Sep 19, 2003 at 09:29:00AM -0600, Kevin Michael Benson wrote: > > I just had to buy a new computer as my old one just got stolen. I just > > installed RH9 on it. I'm having a little trouble getting my NIC running. > > Here's the story. The driver compiled without error. The instructions say that > > you need to type 'insmod 3c2000.o' to load the module. Which I did and it > > loaded correctly. After that, it's 'ifconfig eth0 up', which also loaded > > correctly. When I type 'ifconfig' again, it shows that eth0 is ny NIC and that > > it has sent and recieved data. It has the correct IP address and it found the > > correct DNS server. Everything seems fine. But I've got 2 problems. First, it > > doesn't load at startup. How do I make it do that? 2nd and more importantly, I > > can't do anything with it. How do I connect to the internet now? Thanks > > everyone for your help. > > -Mike Benson
Sorry to reply to a reply while quoting the original, but I deleted it by accident. You can make redhat 9 load any module automatically when eth0 comes up by making sure that there following line exists in /etc/modules.conf: alias eth0 3c2000 That should do it. If you run redhat-config-network, it may also be capable of setting this for you. Michael > > > > > > _______________________________________________ > > newbies mailing list > > [EMAIL PROTECTED] > > http://phantom.byu.edu/cgi-bin/mailman/listinfo/newbies _______________________________________________ newbies mailing list [EMAIL PROTECTED] http://phantom.byu.edu/cgi-bin/mailman/listinfo/newbies
