On 2008/8/8 Jens Hektor <[EMAIL PROTECTED]> wrote:
> Alex Moura schrieb:
>
>> Can anyone confirm if the nfcapd paramenter -R can be used more than once
>> in nfsen.conf, like the example below?
>>
>
> [...]
>
> 'netflow', 'optarg' => '-R 172.16.0.10/9842 <http://172.16.0.10/9842> -R
>> 192.168.0.20/9842 <http://192.168.0.20/9842>' },
>>
>
> Without having looked into the manual or source I would expect a more
> canonically syntax as <ip>:<port> rather than <ip>/<port>.
>
> Did you try that?
I did not.
This syntax works for one destination IP and the documentation says:
-R host[/port}
Enable packet repeater. Send all incoming packets to another
host
and port. host is either a valid IPv4/IPv6 address, or a valid
sym-
bolic hostname, which resolves to a IPv6 or IPv4 address. port
may
be ommited and defaults to port 9995. Note: Due to
IPv4/IPv6
accepted addresses the port separator is '/'.
Alex
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Nfsen-discuss mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/nfsen-discuss
