I see the errors on the switch side, but what about the NOX side? What is the controller saying about the switch? Is the switch disconnecting or is the controller disconnecting the switch? That's critical for understanding what is happening.
Regards KK On 1 December 2010 03:22, Hasnat Ahmed <10msithah...@seecs.edu.pk> wrote: > sorry yapkke , i did not get ur point. > > On Wed, Dec 1, 2010 at 11:57 AM, kk yap <yap...@stanford.edu> wrote: >> >> What about the log from the NOX side of things? >> >> Regards >> KK >> >> On 30 November 2010 22:49, Hasnat Ahmed <10msithah...@seecs.edu.pk> wrote: >> > Hi , while creating a openflow network within a single pc I have >> > verified >> > successfully switch set up part but when tried to setup the controller >> > portion. we are examing a issue. controller port (6663) is in listening >> > mode >> > (fine)but when we start the controller it will 1st show its status >> > connected >> > and then lose the connection and cannot reestablish the connection. so >> > without holding the conntroller connectivity the simulation cant run. >> > >> > kindly see the attached pic. >> > >> > we are not getting out that why controller loses its connectivity. >> > >> > >> > >> > >> > >> > >> > _______________________________________________ >> > nox-dev mailing list >> > nox-dev@noxrepo.org >> > http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org >> > >> > > > _______________________________________________ nox-dev mailing list nox-dev@noxrepo.org http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
