Hi Hasnat, You are not telling me much other than you have some errors going on. It would definitely help if you can tell me what the errors are. Then maybe I can see if I can advise on how to get rid of them. So, can I have the logs? Thanks.
Regards KK PS>> Unless this is meant to be a private email, please don't drop the mailing list. Thanks. On 4 December 2010 06:39, Hasnat Ahmed <10msithah...@seecs.edu.pk> wrote: > now i have redone all the steps mentioned in "CREATE AN OPENFLOW NETWORK > WITHIN A SINGLE PC" my switch portion is verified successfully and drawing > command is also working fine but this time at controller(NOX) portion when i > run the ./nox_core -i ptcp:6633 routing command > it is displaying me that line "openflow compiled" and cursor stays blink > like its in blocking stage etc i dont know > > than when i run a command vms-start.py 2hosts-2ofsw.vms.xml > its shows me error "hda.disk " file is missing. but i have placed this file > and its present. > > On Wed, Dec 1, 2010 at 6:18 PM, kk yap <yap...@stanford.edu> wrote: >> >> I see the errors on the switch side, but what about the NOX side? >> What is the controller saying about the switch? Is the switch >> disconnecting or is the controller disconnecting the switch? That's >> critical for understanding what is happening. >> >> Regards >> KK >> >> On 1 December 2010 03:22, Hasnat Ahmed <10msithah...@seecs.edu.pk> wrote: >> > sorry yapkke , i did not get ur point. >> > >> > On Wed, Dec 1, 2010 at 11:57 AM, kk yap <yap...@stanford.edu> wrote: >> >> >> >> What about the log from the NOX side of things? >> >> >> >> Regards >> >> KK >> >> >> >> On 30 November 2010 22:49, Hasnat Ahmed <10msithah...@seecs.edu.pk> >> >> wrote: >> >> > Hi , while creating a openflow network within a single pc I have >> >> > verified >> >> > successfully switch set up part but when tried to setup the >> >> > controller >> >> > portion. we are examing a issue. controller port (6663) is in >> >> > listening >> >> > mode >> >> > (fine)but when we start the controller it will 1st show its status >> >> > connected >> >> > and then lose the connection and cannot reestablish the connection. >> >> > so >> >> > without holding the conntroller connectivity the simulation cant run. >> >> > >> >> > kindly see the attached pic. >> >> > >> >> > we are not getting out that why controller loses its connectivity. >> >> > >> >> > >> >> > >> >> > >> >> > >> >> > >> >> > _______________________________________________ >> >> > nox-dev mailing list >> >> > nox-dev@noxrepo.org >> >> > http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org >> >> > >> >> > >> > >> > > > _______________________________________________ nox-dev mailing list nox-dev@noxrepo.org http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
