James the reason that the size won't change after you restart the computer is because the system account has been denied access to the drive where the page file resides. Make sure the system account has full access to the system drive. Do you get a pop up message that says something to the fact of "New system settings could not be loaded" as soon as the OS boots to gui? Or something like that? I have seen that whenever I would change system settings, like disabling services, changing page file size. It turned out that the bios wasn't supported on the OS. Believe it or not. I actually flashed an older version of the BIOS and the error went away.
-----Original Message----- From: James Edwards [mailto:[EMAIL PROTECTED]] Sent: Friday, October 05, 2001 2:54 PM To: NT 2000 Discussions Subject: 20 Mg Swap File Greetings All; Hopefully someone has a suggestion for this. I recently upgraded a Win 98 to W2k Pro. Now when it starts up it gives an error message about the swap file being too small. I have set it to be a minimum of 341 mg, but it never initializes to a size greater than 20 mg. There is over a gig of disk space available. Any one have any suggestions?? TIA Jim ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED] ------ You are subscribed as [email protected] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED]
